Discovery 2. Manual — part 480
ENGINE MANAGEMENT SYSTEM - TD5
REPAIRS 18-1-63
Switch - cruise control (set/resume)
$% 19.75.33
Remove
1. Remove the key from the starter switch.
Disconnect both battery leads, negative lead
first. Wait ten minutes before starting work.
2. Remove driver's airbag module.
3. Release remote control switches multiplug and
leads from steering wheel base.
4. Disconnect remote control switches multiplug
from harness.
5. Remove 2 screws securing remote control
switches to steering wheel base.
6. Release and remove remote control switches
from steering wheel.
Refit
1. Fit remote control switches to steering wheel
and secure with screws.
2. Connect remote control switches multiplug to
harness.
3. Secure leads and multiplug to base of steering
wheel.
4. Fit driver's airbag module.
Switch - clutch
$% 19.75.34
Remove
1. Disconnect the multiplug from the clutch switch.
2. Position a container below the clutch switch to
collect the fluid.
3. Unscrew and remove the clutch switch.
CAUTION: Always fit plugs to open
connections to prevent contamination.
Refit
1. Fit the clutch switch and tighten to 10 Nm (7
lbf.ft).
2. Connect the multiplug.
3. Bleed the clutch hydraulic system.
ENGINE MANAGEMENT SYSTEM - TD5
18-1-64 REPAIRS
ENGINE MANAGEMENT SYSTEM - V8
DESCRIPTION AND OPERATION
18-2-1
Deze pagina werd opzettelijk niet gebruikt
Cette page est intentionnellement vierge
Questa pagina è stata lasciata in bianco di proposito
Diese Seite ist leer
Esta página foi deixada intencionalmente em branco
Esta página fue dejada en blanco intencionalmente
This page is intentionally left blank
ENGINE MANAGEMENT SYSTEM - V8
DESCRIPTION AND OPERATION
ENGINE MANAGEMENT SYSTEM - V8
18-2-2
DESCRIPTION AND OPERATION
Engine management component
location - Passenger compartment
LHD illustrated
1 Engine control module
2 Diagnostic connector
3 Malfunction indication lamp
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст