Discovery 2. Manual — part 394
MAINTENANCE
PROCEDURES
10-3
Seats and seat belts
Check
Front seat
Rear seat rear fixings
Rear seat front fixings
1. Check seat frames are secured to floor and
show no signs of movement.
2. Check operation of seat slide and tilt
mechanisms, ensuring there is no excessive
play between seat cushion and seat back.
3. Fully extract seat belt and allow it to return
under its own recoil mechanism. Repeat for
other belts.
4. Check entire length of seat belt webbing for
signs of fraying or damage. Repeat for other
belts.
MAINTENANCE
10-4
PROCEDURES
5. Check security of seat belt upper mountings.
6. Check for correct operation of seat belt height
adjusters.
7. Check security of seat belt buckle mountings.
8. Connect each belt to the correct buckle, check
seat buckle and tongue are secure. Release
seat belt buckle and check for correct
operation.
9. Check tightness of accessible seat belt fixings.
10. Check tightness of accessible seat belt
mountings.
MAINTENANCE
PROCEDURES
10-5
Lamps, horns and warning indicators
Check
1. Switch on side, head and tail lamps and check
operation.
2. Check headlamp levelling operation.
3. Check turn signals and hazard warning lamps
for correct operation.
4. Press brake pedal and check operation of
brake lamps.
5. Check all exterior lamp lenses for clarity and
condition. Pay particular attention to headlamp
lenses for signs of stone chips or damage.
6. Check horn for loud, clear sound.
7. Switch on headlamps (with ignition switch at 'O'
position) and check light reminder warning
operates when door is opened.
8. Check operation of interior courtesy lights.
9. Check operation of all instrument pack warning
and indicator lights.
Wipers and washers
Check
1. Operate screen washer and switch on wipers.
Ensure washer jets are correctly aimed and
check for smooth, smear free operation of
wiper blades across screen at all speeds
including intermittent.
2. Repeat operation for rear screen washers/
wipers.
MAINTENANCE
10-6
PROCEDURES
3. Check all wiper blades for condition and signs
of splits or damage.
4. Check security of wiper arms.
Handbrake
Check
1. With the vehicle stationary, on a level surface,
apply and release handbrake and check for
correct operation.
Alarm handset battery
Replace
1. Insert the blade of a small, flat bladed
screwdriver into the slot at the rear of the
handset and prise the back from the handset.
2. Slide the battery out of the clip taking care not
to touch the circuit board or the battery
contacts.
3. Press and hold one of the buttons for at least 5
seconds.
4. Fit the replacement battery ensuring that
correct polarity is maintained (+) side facing
upwards. Avoid touching the flat surfaces of the
battery.
5. Press the 2 halves of the handset together.
6. Check that handset operates correctly.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст