Discovery 2. Manual — part 87
ENGINE MANAGEMENT SYSTEM - V8
ADJUSTMENTS 18-2-77
ADJUSTMENTS
Cable - throttle
$% 19.20.05
Adjust
1. Loosen outer cable locknuts.
2. Adjust the rear locknut until it is in contact with
the back of the abutment bracket, and the gap
between the throttle and the inner driven lever
is 0.5 mm
±
0.4 mm (0.020
±
0.015 in).
3. Tighten cable front nut to lock cable to
abutment bracket.
Cable - cruise control
$% 19.75.11
Adjust
1. Ensure that the throttle cable is correctly
V8, ADJUSTMENTS, Cable - throttle.
2. Loosen outer cable locknuts.
3. Adjust the rear locknut to obtain a 4.0 to 4.5
mm (0.157 to 0.177 in) gap, dimension 'A',
between the cruise control cable lever and the
throttle cable driven lever.
4. Tighten cable front locknut.
ENGINE MANAGEMENT SYSTEM - V8
REPAIRS 18-2-79
REPAIRS
Spark plugs
$% 18.20.02
Remove
1. Noting their fitted position, disconnect ht leads
from spark plugs.
2. Using a spark plug socket, remove 8 spark
plugs.
Refit
1. Fit terminals to new spark plugs.
CAUTION: Do not attempt to adjust spark
plug gaps.
2. Fit spark plugs and tighten to 25 Nm (18 lbf.ft).
3. Connect ht leads to spark plugs ensuring they
are in the correct position.
ENGINE MANAGEMENT SYSTEM - V8
18-2-80 REPAIRS
Coil - ignition
$% 18.20.45
Remove
1. Remove upper inlet manifold assembly.
SYSTEMS - V8, REPAIRS, Gasket - inlet
manifold - upper - Without Secondary Air
Injection.
2. Disconnect multiplugs from ignition coils.
3. Release ht leads from rocker covers and
disconnect ht leads from spark plugs.
4. Carefully manoeuvre ignition coil assembly
from between engine and bulkhead.
5. Noting their fitted position disconnect ht leads
from ignition coil.
6. Remove 3 screws securing ignition coil to
support bracket and remove coils.
Refit
1. Position ignition coil to support bracket, fit and
tighten screws.
2. Connect ht leads to ignition coil ensuring they
are in the correct position.
3. Carefully position ignition coil assembly
between engine and bulkhead.
4. Connect ht leads to spark plugs and secure ht
leads to rocker covers.
5. Connect multiplugs to ignition coils.
6. Fit upper inlet manifold assembly.
SYSTEMS - V8, REPAIRS, Gasket - inlet
manifold - upper - Without Secondary Air
Injection.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст