Discovery 2. Manual — part 437
ENGINE - V8
REPAIRS 12-2-41
7. Release clip and disconnect coolant hose from
coolant pump.
8. Disconnect multiplug from oil pressure switch.
9. Disconnect multiplug from CMP sensor.
10. If fitted: Loosen union and disconnect oil
cooler pipe from timing gear cover. Remove
and discard 'O' ring.
CAUTION: Always fit plugs to open
connections to prevent contamination.
11. Remove 9 bolts securing timing gear cover and
remove cover. Remove and discard gasket.
Refit
1. Clean mating faces of timing gear cover and
cylinder block. Clean dowels and dowel holes.
2. Fit new gasket, dry, to dowels in cylinder block.
3. Fit timing gear cover to cylinder block and,
working the sequence illustrated, tighten bolts
to 22 Nm (17 lbf.ft) . Ensure CMP sensor
multiplug bracket is secured by bolt.
4. If fitted: Fit new 'O' ring to oil cooler pipe,
connect pipe to timing gear cover and tighten
union to 15 Nm (11 lbf.ft).
5. Connect multiplug to oil pressure switch.
6. Connect multiplug to CMP sensor.
7. Connect coolant hose to coolant pump and
secure with clip.
ENGINE - V8
12-2-42 REPAIRS
8. Ensure mating faces of PAS pump pulley and
drive flange are clean, fit pulley and tighten
bolts to 22 Nm (16 lbf.ft).
9. Remove all traces of thread locking material
from coolant pump pulley drive flange bolt
holes using an M8 tap.
10. Ensure mating faces of coolant pump pulley
and drive flange are clean, fit pulley and tighten
new Patchlok bolts to 22 Nm (16 lbf.ft).
11. Ensure mating faces of oil filter and adaptor are
clean, smear clean engine oil onto seal and fit
filter.
12. Fit timing gear cover oil seal.
ENGINE - V8, REPAIRS, Seal - cover
13. Fit oil pick-up strainer.
ENGINE - V8, REPAIRS, Strainer -
14. Refill cooling system.
ADJUSTMENTS, Drain and refill.
Seal - cover - timing gears
$% 12.65.05
Remove
1. Remove auxiliary drive belt.
REPAIRS, Belt - auxiliary drive.
2. Secure tool LRT-12-080 to crankshaft pulley
with 2 bolts.
3. Remove crankshaft pulley bolt.
4. Remove crankshaft pulley.
5. Use tool LRT-12-088, to remove oil seal from
timing gear cover.
ENGINE - V8
REPAIRS 12-2-43
Refit
1. Clean seal register in timing gear cover and
crankshaft pulley.
2. Apply Retinax LX grease to inner recess of new
oil seal until recess is half filled with grease. Do
not allow grease to coat any other part of
seal. Do not apply oil to seal.
3. Apply smear of Retinax LX grease to seal
running surface on crankshaft.
4. Fit seal to timing gear cover using tool LRT-12-
089 .
5. Fit crankshaft pulley bolt and tighten to 270 Nm
(200 lbf.ft).
6. Remove tool LRT-12-080 from crankshaft
pulley.
7. Fit auxiliary drive belt.
ENGINE - V8
12-2-44 REPAIRS
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст