Discovery 2. Manual — part 214
BRAKES
ADJUSTMENTS
70-31
Bleed sequence LHD
Bleed sequence RHD
11. Working in the sequence illustrated, repeat
steps 5 to 9 on remaining calipers.
WARNING: Braking efficiency may be
seriously impaired if the incorrect bleed
sequence is used.
12. Apply brakes and check for leakage.
13. Remove stand(s) and lower vehicle.
14. Road test vehicle. Check brake pedal for short
firm travel when brakes are applied.
BRAKES
REPAIRS
70-33
REPAIRS
Brake disc - front
$% 70.12.10
Brake discs must be renewed in pairs, unless
one disc requires changing before 1000 miles
(1500 km) from new.
Remove
1. Raise front of vehicle.
WARNING: Do not work on or under a
vehicle supported only by a jack. Always
support the vehicle on safety stands.
2. Remove road wheel(s).
3. Remove 2 bolts securing brake caliper to
swivel hub.
4. Release caliper and tie aside clear of brake
disc.
CAUTION: Do not allow caliper to hang on
brake hose.
5. Remove screw securing disc to drive flange.
6. Remove brake disc from drive flange
Refit
1. Clean mating faces of drive flange and new
disc.
2. Fit brake disc to drive flange, fit screw and
tighten to 13 Nm (10 lbf.ft).
3. Clean mating faces of caliper and hub.
4. Fit caliper, and tighten bolts to 175 Nm (129
lbf.ft).
5. Fit road wheel(s) and tighten nuts to 140 Nm
(103 lbf.ft).
6. Remove stand(s) and lower vehicle.
BRAKES
70-34
REPAIRS
Brake disc - rear
$% 70.12.33
Brake discs must be renewed in pairs, unless
one disc requires changing before 1000 miles
(1500 km) from new.
Remove
1. Raise rear of vehicle.
WARNING: Do not work on or under a
vehicle supported only by a jack. Always
support the vehicle on safety stands.
2. Remove road wheel(s).
3. Remove 2 bolts securing brake caliper to rear
hub.
4. Release caliper and tie aside clear of brake
disc.
CAUTION: Do not allow caliper to hang on
brake hose.
5. Remove screw securing disc to drive flange.
6. Remove brake disc from drive flange.
Refit
1. Clean mating faces of drive flange and new
disc.
2. Fit brake disc to drive flange, fit screw and
tighten to 13 Nm (10 lbf.ft).
3. Clean mating faces of caliper and hub.
4. Fit caliper and tighten bolts to 95 Nm (70 lbf.ft).
5. Fit road wheel(s) and tighten nuts to 140 Nm
(103 lbf.ft).
6. Remove stand(s) and lower vehicle.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст