Range Rover. Manual — part 114
CRUISE CONTROL
1
REPAIR
CRUISE CONTROL ECU
Service repair no - 19.75.49
Remove
1. Remove fascia closing panel.
See CHASSIS
AND BODY, Repair.
2. Remove 2 bolts securing ECU bracket to fascia.
Release bracket to gain access to fixings.
3. Disconnect multiplug from ECU.
4. Remove 2 bolts securing ECU. Remove ECU.
Refit
5. Reverse removal procedure.
CRUISE CONTROL ACTUATOR
Service repair no - 19.75.05
Remove
1. Disconnect vacuum hose from actuator.
2. Disconnect control cable from ball joint on
actuator diaphragm.
3. Remove nut securing actuator to bracket.
Remove actuator.
Refit
4. Position actuator to bracket. Secure with nut.
5. Connect vacuum hose. Secure cable to actuator
ball joint.
6. Adjust cruise control cable.
See CRUISE
CONTROL, Adjustment.
19
FUEL SYSTEM
NEW RANGE ROVER
2
REPAIR
SET AND RESUME SWITCHES - CRUISE
CONTROL
Service repair no - 19.75.36 - Set Switch
Service repair no - 19.75.37 - Resume Switch
Remove
1. Remove steering wheel switch pack assembly.
See ELECTRICAL, Repair.
Refit
2. Reverse removal procedure.
CRUISE CONTROL - VACUUM CONTROL UNIT
Service repair no - 19.75.06
Remove
1. Remove 2 screws securing actuator bracket.
2. Release cover and disconnect multiplug from
vacuum control unit.
CRUISE CONTROL
3
REPAIR
3. Remove vacuum hose from control unit.
4. Release 3 rubber mountings and remove control
unit.
5. Remove 3 rubber mountings from control unit.
Refit
6. Fit rubber mountings to control unit.
7. Position control unit and secure mountings.
8. Connect vacuum hose to control unit.
9. Connect multiplug and fit cover.
10. Position actuator bracket and secure with
screws.
BRAKE AND CLUTCH PEDAL SWITCHES/VENT
VALVES - CRUISE CONTROL
Service repair no - 19.75.34 - Clutch Switch
Service repair no - 19.75.35 - Brake Switch (not
fitted to diesel variants)
Remove
1. Remove drivers side fascia closing panel.
See
CHASSIS AND BODY, Repair.
2. Remove 3 scrivet fasteners securing lower
closing panel. Release panel to gain access to
blower motor ducting.
3. Release ducting from blower motor housing and
heater. Remove blower motor ducting.
4. Release switch/vent valve from pedal bracket.
19
FUEL SYSTEM
NEW RANGE ROVER
4
REPAIR
5. Disconnect vacuum hose and multiplug from
switch.
NOTE: Vacuum hose fitted to petrol
variants only.
6. Remove switch/vent valve.
Refit
7. Reverse removal procedure.
NOTE: The switch/vent valve is factory set
and does not require adjustment in
service.
CRUISE CONTROL - SWITCH
INVERTER/CONVERTER
Service repair no - 19.75.22
NOTE: Inverter is used on petrol, converter
on diesel. Units are in same position and
are visually similar. Illustration 19M7054
shows petrol condition, diesel vehicles do not
have the cruise control ECU.
Remove
1. Remove fascia closing panel.
See CHASSIS
AND BODY, Repair.
2. Release inverter/converter multiplug from
bracket.
3. Remove inverter/converter from multiplug.
Refit
4. Reverse removal procedure.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст