Range Rover. Manual — part 127
LAND ROVER V8
7
REPAIR
WATER PUMP - FROM 99MY
Service repair no - 26.50.01
Remove
1. Drain cooling system.
See this section.
2. Loosen 3 bolts securing water pump pulley to
water pump.
3. Remove auxiliary drive belt.
See ELECTRICAL,
Repair.
4. Remove 3 bolts securing pulley to water pump
and remove pulley.
5. Release clip and disconnect coolant hose from
water pump.
6. Remove 9 bolts securing water pump, remove
water pump and discard gasket.
Refit
7. Clean water pump and mating face.
8. Fit new gasket and water pump, tighten bolts to
24 Nm (18 lbf.ft).
9. Connect coolant hose to water pump and secure
with clip.
10. Ensure mating faces of water pump pulley and
flange are clean, fit pulley and tighten bolts to
22 Nm (17 lbf.ft).
11. Fit auxiliary drive belt.
See ELECTRICAL,
Repair.
12. Refill cooling system.
See this section.
26
COOLING SYSTEM
NEW RANGE ROVER
8
REPAIR
THERMOSTAT - UP TO 99MY
Service repair no - 26.45.01
Remove
1. Disconnect battery earth lead.
2. Raise vehicle on 4 post ramp.
3. Remove engine acoustic cover (if applicable).
See CHASSIS AND BODY, Repair.
4. Drain cooling system.
See this section.
5. Loosen 3 upper hose clips and disconnect 3
hoses from top of thermostat housing.
6. Loosen lower hose clip and disconnect hose
from bottom of thermostat housing.
7. Release 2 clips securing thermostat to housing
radiator cowl and remove thermostat housing.
Refit
8. Position thermostat housing and connect to
radiator hose.
9. Connect hoses to top of thermostat housing.
10. Tighten clips securing hoses to thermostat
housing.
11. Engage thermostat housing to radiator cowl
clips.
12. Fill coolant system.
See this section.
13. Fit engine acoustic cover (if applicable).
See
CHASSIS AND BODY, Repair.
THERMOSTAT - FROM 99MY
Service repair no - 26.45.09
Remove
1. Drain cooling system.
See this section.
2. Remove cooling fan.
See this section.
3. Release 3 clips and disconnect coolant hoses
from thermostat.
4. Release clip securing thermostat to fan cowl and
remove thermostat.
Refit
5. Position thermostat and secure to cowl.
6. Fit hoses to thermostat and secure with clips.
7. Fit cooling fan.
See this section.
8. Fill cooling system.
See this section.
LAND ROVER V8
9
REPAIR
EXPANSION TANK
Service repair no - 26.15.01
NOTE: This operation covers all models
Remove
1. Position container to collect coolant spillage.
2. Disconnect heater hose and radiator bleed hose
from expansion tank.
3. Release expansion tank from clips.
4. Petrol only: Disconnect throttle housing coolant
bleed hose from expansion tank.
5. Remove expansion tank.
Refit
6. Reverse removal procedure.
7. Check and top up cooling system.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст