Frelander 2. Manual — part 583
Handles, Locks, Latches and Entry Systems - Liftgate Striker Adjustment
General Procedures
Check for an equal gap and alignment to the adjacent
panels. If incorrect, follow the adjust procedure below.
1.
Remove the spare wheel cover.
2.
Remove the loadspace scuff plate.
3.
Loosen the 2 liftgate striker bolts.
4.
Close the liftgate and check for an equal gap and alignment to the
adjacent panels.
5.
Open the liftgate and tighten the liftgate striker bolts.
Torque: 25 Nm
6.
Install the loadspace scuff plate.
7.
Install the spare wheel cover.
8.
Handles, Locks, Latches and Entry Systems - Front Door Latch
Removal and Installation
Removal
Disconnect the battery ground cable.
Refer to:
Specifications
(414-00 Battery and Charging System -
General Information, Specifications).
1.
Remove the window motor and regulator assembly.
Refer to:
Front Door W indow Regulator and Motor
(501-11 Glass,
Frames and Mechanisms, Removal and Installation).
2.
3.
CAUTION: Release the exterior door handle and screw cover
clips from inside the door.
Remove the front door exterior handle.
Refer to:
Exterior Front Door Handle
(501-14 Handles, Locks, Latches
and Entry Systems, Removal and Installation).
3.
Release the remote control cable.
4.
Release the door exterior handle mechanism.
5.
Remove the front door latch assembly.
6.
7. NOTE: Do not disassemble further if the component
is removed for access only.
Remove the door latch remote control cable.
7.
Release the exterior door handle mechanism cable from
the door latch.
8.
LH side: Release the door lock cylinder cable from the
door latch.
9.
Installation
LH side: Connect the door lock cylinder cable to the door latch.
1.
Connect the door exterior handle mechanism cable to the door latch.
2.
Install the remote control cable to the door latch.
3.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст