Frelander 2. Manual — part 601
Roof Opening Panel - Motor Synchronization
General Procedures
1.
Set the ignition to the ON position.
With the roof opening panel closed, press and hold the
front of the roof opening panel switch until the roof
opening panel has moved to the tilted open position.
Release the roof opening panel switch.
2.
Press the front of the roof opening panel switch.
After 20 seconds the roof opening panel will begin to
move.
Keep the front of the roof opening panel switch pressed
until the roof opening panel have fully opened, then
closed.
3.
Once the open/close cycle has completed and the roof
opening panel has stopped moving, release the switch.
The roof opening panel is now synchronized.
The roof opening panel can now be operated as normal.
Roof Opening Panel - Roof Opening Panel
Removal and Installation
Removal
• CAUTIONS:
Protect the surrounding paintwork to avoid damage.
Protect the surrounding trim to avoid damage.
Remove the rear section of the roof moulding.
Remove the 2 clips.
W orking from the rear end, carefully release the
moulding.
1.
Remove the front section of the roof moulding.
W orking from the rear end, carefully release the
moulding.
Release the 2 clips.
2.
Repeat steps 1 and 2 for the other side.
3.
Partially open the roof opening panel glass for access.
4.
Remove the headliner.
Refer to:
Headliner - Vehicles With: Tilting Roof Opening Panel
(501-05 Interior Trim and Ornamentation, Removal and Installation).
5.
Disconnect the drain tubes.
6.
Release the roof opening panel tethers.
7.
8.
WARNING: Wear safety goggles and protective
gloves.
• CAUTIONS:
Protect the surrounding paintwork to avoid
damage.
Protect the surrounding trim to avoid damage.
If the original roof opening panel is to be
installed, take care not to damage the locating pegs.
• NOTE: This step requires the aid of another
technician.
Feed the glazing wire through the roof opening
panel sealant to the inside of the vehicle.
W orking in a counter clockwise direction, cut the
sealant upto the front locating peg.
8.
9.
CAUTION: If the original roof opening panel is to
be installed, take care not to damage the locating pegs.
• NOTE: This step requires the aid of another technician.
Working in a clockwise direction, cut the sealant
upto the front locating peg.
9.
Close the roof opening panel glass.
10.
11.
CAUTION: Do not lift the roof opening panel by the blinds.
• NOTE: This step requires the aid of another technician.
W ith assistance, remove the roof opening panel assembly.
11.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст