Frelander 2. Manual — part 521
Multifunction Electronic Modules - Driver Seat Module (DSM)
Removal and Installation
Removal
• NOTE: Removal steps in this procedure may contain installation details.
Remove the cover and disconnect the battery ground cable.
Refer to:
Specifications
(414-00 Battery and Charging System -
General Information, Specifications).
1.
Torque: 7 Nm
2.
Installation
To install, reverse the removal procedure.
1.
Using the Land Rover approved diagnostic system, calibrate a new
module.
2.
Front End Body Panels -
Torque Specifications
Description
Nm
lb-ft
Coldzone main panel screws
10
7
Engine undershield bolts
60
42
Fender splash shield
6
4
Front fender bolts
10
7
Hood hinge bolts
24
18
Hood latch panel bolts
24
18
Secondary bulkhead center panel
10
7
Front End Body Panels -
Torque Specifications
Description
Nm
lb-ft
Coldzone main panel screws
10
7
Engine undershield bolts
60
42
Fender splash shield
6
4
Front fender bolts
10
7
Hood hinge bolts
24
18
Hood latch panel bolts
24
18
Secondary bulkhead center panel
10
7
Front End Body Panels - Fender Splash Shield
Removal and Installation
Removal
1.
WARNING: Do not work on or under a vehicle supported only
by a jack. Always support the vehicle on safety stands.
Raise and support the vehicle.
1.
Remove the front wheel.
Refer to:
Wheel and Tire
(204-04 W heels and Tires, Removal and
Installation).
2.
Remove the fender splash shield extension panel.
3.
4.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст