Frelander 2. Manual — part 112
Rear Disc Brake - Brake Caliper Anchor Plate
Removal and Installation
Removal
1.
WARNING: Make sure to support the vehicle with axle
stands.
Raise and support the vehicle.
1.
Remove the wheel and tire.
Refer to:
Wheel and Tire
(204-04 W heels and Tires, Removal and
Installation).
2.
3.
4.
5.
6.
CAUTION: Do not allow the brake caliper to hang on the
6.
brake hose.
Tie the brake caliper housing aside.
7.
8.
Installation
1.
WARNING: Do not use compressed air to clean brake
components. Dust from friction materials can be harmful if inhaled.
Clean the brake caliper housing and anchor plate using brake
cleaning fluid.
1.
Clean and lubricate the guide pins.
2.
Install the guide pins.
3.
4.
CAUTION: Make sure that new bolts are installed.
Install the brake caliper anchor plate.
Torque: 110 Nm
4.
5.
CAUTION: Make sure that new bolts are installed.
Install the brake caliper housing and install the top bolt.
Torque: 35 Nm
5.
Install the clips and brake pads.
6.
7. CAUTIONS:
7.
Make sure that new bolts are installed.
Make sure that the brake hose is not twisted and is correctly
located.
Align the brake caliper to the anchor plate.
Torque: 30 Nm
Install the wheel and tire.
Refer to:
Wheel and Tire
(204-04 W heels and Tires, Removal and
Installation).
8.
Parking Brake and Actuation -
General Specification
Item
Specification
Make
TRW
Type
Drum machined in centre of the brake disc
Operation
Manually applied cable operated system.
Parking brake drum internal diameter
185 mm (7.28 in)
Minimum brake lining material thickness
1 mm (0.039 in)
Torque Specifications
Description
Nm
lb-ft
LH/RH parking brake cable bolts
10
7
Parking brake actuator mounting bracket bolts
25
18
Parking brake warning indicator switch Torx screw
2
1
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст