Frelander 2. Manual — part 509
Torque: 10 Nm
Connect the CKP sensor electrical connector.
12.
Connect the generator electrical connector.
Torque: 10 Nm
13.
Connect the KS electrical connectors.
14.
Connect and secure the ECT sensor electrical connector.
15.
Connect the fuel injector electrical connectors.
16.
Connect the coil-on-plug electrical connectors.
17.
Disconnect the variable camshaft timing solenoids.
18.
Connect the HO2S electrical connectors.
19.
Connect the ECM electrical connectors.
20.
Install the engine mount.
Refer to:
Engine Mount RH
(303-01A Engine - I6 3.2L Petrol,
Removal and Installation).
21.
Install the intake manifold.
Refer to:
Intake Manifold
(303-01A Engine - I6 3.2L Petrol, Removal
and Installation).
22.
Install the air intake plenum.
Refer to:
Plenum Chamber
(412-01 Climate Control, Removal and
Installation).
23.
Install the battery tray.
Refer to:
Battery Tray
(414-01 Battery, Mounting and Cables,
Removal and Installation).
24.
Connect the battery ground cable and install the cover.
Refer to:
Specifications
(414-00 Battery and Charging System -
General Information, Specifications).
25.
Wiring Harnesses - Engine Wiring HarnessTD4 2.2L Diesel
Removal and Installation
Removal
• NOTE: Make sure the wiring harness is routed correctly.
All vehicles
Remove the air cleaner housing.
Refer to:
Air Cleaner
(303-12B Intake Air Distribution and Filtering -
TD4 2.2L Diesel, Removal and Installation).
1.
Remove the fuel filter.
Refer to:
Fuel Filter
(310-01B Fuel Tank and Lines - TD4 2.2L Diesel,
Removal and Installation).
2.
Remove the engine compartment closing panel.
Refer to:
Secondary Bulkhead Center Panel - TD4 2.2L Diesel
(501-02 Front End Body Panels, Removal and Installation).
3.
Remove the battery carrier.
Refer to:
Battery Tray
(414-01 Battery, Mounting and Cables,
Removal and Installation).
4.
Remove the engine undershield.
Refer to:
Engine Undershield
(501-02 Front End Body Panels,
Removal and Installation).
5.
Remove the front RH splash shield.
Refer to:
Fender Splash Shield
(501-02 Front End Body Panels,
Removal and Installation).
6.
7.
WARNING: Make sure to support the vehicle with axle
stands.
Raise and support the vehicle.
7.
All vehicles
Torque: 10 Nm
8.
9.
10.
11.
12.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст