Frelander 2. Manual — part 355
Clutch Controls - Clutch Slave Cylinder
Removal and Installation
Removal
• NOTE: The clutch slave cylinder and release bearing are a combined assembly and cannot be serviced separately.
Disconnect the battery ground cable.
Refer to:
Specifications
(414-00 Battery and Charging System -
General Information, Specifications).
1.
2.
WARNING: Make sure to support the vehicle with axle
stands.
Raise and support the vehicle.
2.
Remove the transmission assembly.
Refer to:
Transmission
(308-03 Manual Transmission/Transaxle,
Removal).
3.
4.
CAUTION: If brake fluid is spilt on the paintwork,
the affected area must be immediately washed down with
cold water.
Torque: 11 Nm
4.
Installation
To install, reverse the removal procedure.
1.
Bleed the clutch system.
Refer to:
Clutch System Bleeding
(308-00 Manual
Transmission/Transaxle and Clutch - General Information, General
Procedures).
2.
Install the transmission.
Refer to:
Transmission
(308-03 Manual Transmission/Transaxle,
Removal).
3.
Connect the battery ground cable.
Refer to:
Specifications
(414-00 Battery and Charging System -
General Information, Specifications).
4.
Clutch Controls - Clutch Master CylinderRHD AWD
Removal and Installation
Removal
Remove the clutch pedal assembly.
Refer to:
Clutch Pedal - RHD AW D
(308-02 Clutch Controls, Removal
and Installation).
1.
Installation
Install the clutch pedal assembly.
Refer to:
Clutch Pedal - RHD AW D
(308-02 Clutch Controls, Removal
and Installation).
1.
Clutch Controls - Clutch Master CylinderLHD AWD
Removal and Installation
Removal
Remove the clutch pedal assembly.
Refer to:
Clutch Pedal - LHD AWD
(308-02 Clutch Controls, Removal
and Installation).
1.
Installation
Install the clutch pedal assembly.
Refer to:
Clutch Pedal - LHD AWD
(308-02 Clutch Controls, Removal
and Installation).
1.
Clutch Controls - Clutch PedalRHD AWD
Removal and Installation
Removal
Disconnect the battery ground cable.
Refer to:
Specifications
(414-00 Battery and Charging System -
General Information, Specifications).
1.
Remove the secondary bulkhead center panel.
Refer to:
Secondary Bulkhead Center Panel - TD4 2.2L Diesel
(501-02 Front End Body Panels, Removal and Installation).
2.
3.
CAUTION: Brake fluid will damage paint
finished surfaces. If spilled, immediately remove the
fluid and clean the area with water.
• NOTE: Position cloth to collect fluid spillage.
3.
4. NOTE: If equiped
4.
Remove the driver lower air bag.
Refer to:
Driver Lower Air Bag Module
(501-20B Supplemental
Restraint System, Removal and Installation).
5.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст