Frelander 2. Manual — part 247
Remove the throttle body.
6.
Remove and discard the gasket.
7.
Installation
Clean the component mating faces.
1.
Install a new gasket.
2.
3.
CAUTION: Make sure that the mating faces are
clean and free of foreign material.
Install the throttle body and tighten the screws in the
sequence shown.
Torque: 8 Nm
3.
Install the engine undershield.
Refer to:
Engine Undershield
(501-02 Front End Body Panels,
Removal and Installation).
4.
Install the front undershield.
5.
Install the front towing eye cover.
6.
Fuel Charging and Controls - I6 3.2L Petrol - Fuel Injector
Removal and Installation
Removal
• NOTE: The process to remove a fuel injector is shown the the Fuel Rail procedure.
Remove the fuel injector.
Refer to:
Fuel Rail
(303-04A Fuel Charging and Controls - I6 3.2L
Petrol, Removal and Installation).
1.
Installation
Install the fuel injector.
Refer to:
Fuel Rail
(303-04A Fuel Charging and Controls - I6 3.2L
Petrol, Removal and Installation).
1.
Fuel Charging and Controls - I6 3.2L Petrol - Fuel Rail
Removal and Installation
Removal
WARNING: Wait for a minimum of 1 minute after the engine has stopped before carrying out any repair to the fuel
injection system.
Remove the cover and disconnect the battery ground cable.
Refer to:
Specifications
(414-00 Battery and Charging System -
General Information, Specifications).
1.
Remove the engine cover.
Refer to:
Engine Cover - I6 3.2L Petrol
(501-05 Interior Trim and
Ornamentation, Removal and Installation).
2.
3. WARNINGS:
Avoid flames, sparks or lighted substances.
Be prepared to collect escaping fuel.
Release the fuel pressure.
3.
4.
5. CAUTIONS:
Extreme cleanliness must be exercised when
handling these components.
Make sure that all openings are sealed.
5.
6. NOTE: Do not remove the fuel injectors, if the rail is
being removed for access.
6.
7.
CAUTION: A new O-ring seal is to be installed.
7.
8.
CAUTION: Cap the fuel injector nozzle to
prevent damage before storing vertically.
• NOTE: Do not disassemble further if the component is
removed for access only.
• NOTE: If the fuel injectors are not being removed
from the fuel rail only the lower O-ring seals will need
to be renewed.
Remove and discard the fuel injector O-ring seals.
8.
9.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст