Frelander 2. Manual — part 402
Remove the nut and bolt securing the fuel tank
filler pipe to the body.
Torque: 10 Nm
Loosen the fuel tank filler pipe lower bracket.
Torque: 10 Nm
Loosen the clip and disconnect the fuel filler
hose from the fuel tank.
Loosen the clip and disconnect fuel filler pipe
vent hose.
6.
Torque: 10 Nm
7.
Installation
To install, reverse the removal procedure.
1.
Fuel Tank and Lines - TD4 2.2L Diesel - Fuel Filter
Removal and Installation
Removal
• W ARNINGS:
W ait for a minimum of 1 minute after the engine has stopped before carrying out any repair to the fuel injection
system.
Avoid flames, sparks or lighted substances.
Be prepared to collect escaping fuel.
Disconnect the battery ground cable.
Refer to:
Specifications
(414-00 Battery and Charging System -
General Information, Specifications).
1.
Remove the engine cover.
Refer to:
Engine Cover - TD4 2.2L Diesel
(501-05 Interior Trim and
Ornamentation, Removal and Installation).
2.
3.
Torque: 9 Nm
4.
5. CAUTIONS:
Make sure that no strain is placed on the fuel
lines and wiring harnesses.
Make sure that the fuel pressure has dropped to
zero and that the fuel temperature is at ambient
temperature.
Be prepared to collect escaping fuel.
Make sure that all openings are sealed. Use new
blanking caps.
Extreme cleanliness must be exercised when
handling this component.
5.
Torque: 9 Nm
6.
7.
Installation
To install, reverse the removal procedure.
1.
Bleed the fuel system.
Refer to:
Fuel System Bleeding - TD4 2.2L Diesel
(310-00 Fuel
System - General Information, General Procedures).
2.
Fuel Tank and Lines - TD4 2.2L Diesel - Fuel Pump and Sender Unit
Removal and Installation
Removal
• NOTE: Removal steps in this procedure may contain installation details.
Disconnect the battery ground cable.
Refer to:
Specifications
(414-00 Battery and Charging System -
General Information, Specifications).
1.
Remove the fuel filter.
Refer to:
Fuel Filter
(310-01B Fuel Tank and Lines - TD4 2.2L Diesel,
Removal and Installation).
2.
3.
CAUTION: Extreme cleanliness must be
exercised when handling these components.
3.
Installation
To install, reverse the removal procedure.
1.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст