Frelander 2. Manual — part 124
Power Brake Actuation - Brake Vacuum PumpI6 3.2L Petrol
Removal and Installation
Removal
• NOTE: Removal steps in this procedure may contain installation details.
Remove the cover and disconnect the battery ground cable.
Refer to:
Specifications
(414-00 Battery and Charging System -
General Information, Specifications).
1.
Remove the engine cover.
Refer to:
Engine Cover - I6 3.2L Petrol
(501-05 Interior Trim and
Ornamentation, Removal and Installation).
2.
Remove the battery tray.
Refer to:
Battery Tray
(414-01 Battery, Mounting and Cables,
Removal and Installation).
3.
Remove the air cleaner assembly.
Refer to:
Air Cleaner
(303-12B Intake Air Distribution and Filtering -
TD4 2.2L Diesel, Removal and Installation).
4.
Remove the A/C compressor, upper support bracket.
Torque:
M10 45 Nm
M8 25 Nm
M6 10 Nm
5.
Disconnect the brake booster vacuum line from the brake vacuum
pump.
6.
7. NOTE: Make sure that this component is installed to
the noted removal position.
Remove the brake vacuum pump.
Torque: 17 Nm
7.
Installation
1. NOTE: Make sure that the component is clean, free of foreign
material and lubricant.
To install, reverse the removal procedure.
1.
Power Brake Actuation - Brake Vacuum PumpTD4 2.2L Diesel
Removal and Installation
Removal
• NOTE: Removal steps in this procedure may contain installation details.
Remove the cover and disconnect the battery ground cable.
Refer to:
Specifications
(414-00 Battery and Charging System -
General Information, Specifications).
1.
Remove the engine cover.
Refer to:
Engine Cover - TD4 2.2L Diesel
(501-05 Interior Trim and
Ornamentation, Removal and Installation).
2.
Remove the air cleaner assembly.
Refer to:
Air Cleaner
(303-12B Intake Air Distribution and Filtering -
TD4 2.2L Diesel, Removal and Installation).
3.
Torque: 9 Nm
4.
5.
6.
CAUTION: Make sure that all openings are
sealed.
6.
7.
CAUTION: The seals are to be reused unless
damaged.
Torque: 9 Nm
7.
8. NOTE: Do not disassemble further if the component
is removed for access only.
Torque: 9 Nm
8.
Installation
1.
CAUTION: Make sure that the mating faces are clean and
free of foreign material.
To install, reverse the removal procedure.
1.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст