Frelander 2. Manual — part 164
Engine - I6 3.2L Petrol - Valve Clearance Check
General Procedures
Special Tool(s)
303-1235
Holder, Camshaft
• NOTE: Only the exhaust cam shaft has adjustable tappets.
1.
WARNING: Make sure to support the vehicle with axle
stands.
Raise and support the vehicle.
1.
Remove the cover and disconnect the battery ground cable.
Refer to:
Specifications
(414-00 Battery and Charging System -
General Information, Specifications).
2.
Remove the camshaft bearing housing.
Refer to:
Valve Cover
(303-01A Engine - I6 3.2L Petrol, Removal and
Installation).
3.
Using the special tools, position and secure the
exhaust camshaft.
Special Tool(s):
303-1235
4.
Using the original bolt, install the camshaft sprocket and lightley
tighten.
5.
For valve clearance data, refer to specifications.
Refer to:
Specifications
(303-01A Engine - I6 3.2L Petrol,
Specifications).
6.
Using a feeler gauge, measure the clearance between
the camshaft and the valve shim.
7.
Remove the camshaft sprocket.
8.
Remove the special tools.
9.
Install the camshaft bearing housing.
Refer to:
Valve Cover
(303-01A Engine - I6 3.2L Petrol, Removal and
Installation).
10.
Connect the battery ground cable and install the cover.
Refer to:
Specifications
(414-00 Battery and Charging System -
General Information, Specifications).
11.
Engine - I6 3.2L Petrol - Hydraulic Lash Adjuster Priming
General Procedures
• NOTE: Hydraulic lash adjusters are fitted to the intake camshaft only.
Check the engine oil level.
1.
If lash adjuster noise occurs when the engine is started, allow the
engine to warm at idle for 1 minute (at -20 degrees celsius allow the
engine to warm for 5 minutes).
2.
Run the engine at 3500 RPM for 1 minute.
3.
Allow the engine to idle for 30 seconds.
4.
If the valve train noise is still present, repeat the above up to a
maximum of 6 times.
5.
Engine - I6 3.2L Petrol - Intake Manifold
Removal and Installation
Removal
Disconnect the battery ground cable.
Refer to:
Specifications
(414-00 Battery and Charging System -
General Information, Specifications).
1.
Remove the engine cover.
Refer to:
Engine Cover - I6 3.2L Petrol
(501-05 Interior Trim and
Ornamentation, Removal and Installation).
2.
Remove the air cleaner assembly.
Refer to:
Air Cleaner
(303-12B Intake Air Distribution and Filtering -
TD4 2.2L Diesel, Removal and Installation).
3.
4.
WARNING: Do not work on or under a vehicle supported only
by a jack. Always support the vehicle on safety stands.
Raise and support the vehicle.
4.
Remove the engine undershield.
Refer to:
Engine Undershield
(501-02 Front End Body Panels,
Removal and Installation).
5.
6.
7.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст