Frelander 2. Manual — part 352
Attach the clear bleed tube to the clutch bleed screw
and immerse the free end of the bleed tube in a bleed
jar containing a small quantity of approved brake fluid.
5.
Loosen the bleed screw by two complete turns.
6.
7.
CAUTION: The brake fluid reservoir must remain full with
new, clean brake fluid at all times during bleeding.
Depress the clutch pedal steadily through its full stroke. W ith the
pedal held down, close the bleed screw. W hen the bleed screw is
fully closed, allow the clutch pedal to return to the rest position.
Repeat the procedure until a flow of clean, air-free fluid is being
pumped into the bleed jar.
7.
8.
CAUTION: Make sure the bleed screw cap is installed after
bleeding. This will prevent corrosion to the bleed screw.
W ith the clutch pedal fully depressed, tighten the bleed screw.
Torque: 10 Nm
8.
Fill the brake fluid reservoir to the MAX mark.
9.
Manual Transmission/Transaxle and Clutch - General Information -
Gearshift Cable Adjustment
General Procedures
Check the gearshift operation.
1.
Position the gearshift lever in NEUTRAL.
2.
Remove the gear selector knob.
Refer to:
Gearshift Lever Knob
(308-06 Manual
Transmission/Transaxle External Controls, Removal and
Installation).
3.
4.
5.
Release the LH cable securing clip.
Allow the gearshift lever to come to rest in the
neutral position.
Secure the cable selector clip, without disturbing
the gearshift selector lever position.
6.
Secure the gear selector cover.
7.
Install the stowage compartment tray.
8.
Install the gear selector knob.
Refer to:
Gearshift Lever Knob
(308-06 Manual
Transmission/Transaxle External Controls, Removal and
Installation).
9.
Clutch -
Lubricants, Fluids, Sealers and Adhesives
Item
Specification
Recommended hydraulic fluid
SHELL DONAX YB DOT4 ESL FLUID
General Specification
Item
Specification
Clutch make/type
LUK - Self adjusting clutch
Clutch size
250 mm (9.84 in)
Clutch plate friction material
Valeo 810 DS
Master cylinder make
FTE
Slave cylinder make/type
FTE Concentric slave cylinder
Torque Specifications
Description
Nm
lb-ft
Clutch cover to flywheel bolts - vehicles built up to 11MY* +
23
17
Clutch cover to flywheel bolts - vehicles built 11MY onwards* +
29
21
* Tighten bolts progressively by diagonal selection.
+ New bolts must be installed.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст