Frelander 2. Manual — part 366
Secure the earth cable to the transmission mounting
bracket.
Torque: 25 Nm
4.
Install the turbocharger outlet pipe.
5.
Install the front flywheel closing panel.
Torque: 60 Nm
6.
Stage 1:
Stage 2:
Install the RH halfshaft.
Torque:
Drive shaft support 25 Nm
7.
Install the LH halfshaft.
8.
Install the alignment tool to the front subframe.
9.
10.
CAUTION: Make sure that new subframe bolts
are installed.
• NOTE: Install but do not fully tighten the front
subframe mounting bolts.
Install the front subframe.
Torque:
Support bracket bolts 25 Nm
Subframe bolts
140 Nm
240°
10.
Stage 1:
Stage 2:
11.
CAUTION: Make sure that new bolts are
installed.
• NOTE: Install but do not fully tighten the rear
subframe mounting bolts.
Install the subframe cross-brace.
Torque:
Cross brace bolts 45 Nm
Subframe bolts
140 Nm
240°
11.
Install the lower support insulator.
Torque: 110 Nm
12.
Install the fuel line.
13.
Connect the steering gear pressure lines.
Torque: 25 Nm
14.
Install the power steering fluid line to the clip.
15.
Secure the downpipe catalytic converter.
16.
17.
WARNING: Make sure that new nuts are
installed.
Connect the LH and RH tie-rod end ball joints.
Torque: 80 Nm
17.
18.
WARNING: Make sure that a new lower arm
ball joint nut is installed.
CAUTION: Make sure that the ball joint ball does
not rotate.
Install the lower arm ball joint
Torque: 110 Nm
18.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст