Frelander 2. Manual — part 306
• NOTE: If diagnostic trouble codes are recorded and, after performing the pinpoint tests, a fault is not present, an
intermittent concern may be the cause. Always check for loose connections and corroded terminals.
For a complete list of all Diagnostic Trouble Codes (DTCs) that could be logged on this vehicle, please refer to Section
100-00REFER to:
Diagnostic Trouble Code (DTC) Index - I6 3.2L Petrol, DTC: Engine Control Module (ECM)
(100-00 General
Information, Description and Operation).
Electronic Engine Controls - I6 3.2L Petrol - Camshaft Position (CMP)
Sensor
Removal and Installation
Removal
• NOTE: Removal steps in this procedure may contain installation details.
Remove the engine cover.
Refer to:
Engine Cover - I6 3.2L Petrol
(501-05 Interior Trim and
Ornamentation, Removal and Installation).
1.
2.
3. CAUTIONS:
Note the fitted position of the special washer.
Discard the seal.
Torque: 10 Nm
3.
Installation
1. CAUTIONS:
Make sure that the mating faces are clean and free of
corrosion and foreign material.
A new O-ring seal is to be installed.
To install, reverse the removal procedure.
1.
Electronic Engine Controls - I6 3.2L Petrol - Crankshaft Position (CKP)
Sensor
Removal and Installation
Removal
• NOTE: Removal steps in this procedure may contain installation details.
1.
WARNING: Do not work on or under a vehicle supported only
by a jack. Always support the vehicle on safety stands.
Raise and support the vehicle.
1.
Remove the engine undershield.
Refer to:
Engine Undershield
(501-02 Front End Body Panels,
Removal and Installation).
2.
Torque: 10 Nm
3.
Installation
To install, reverse the removal procedure.
1.
Electronic Engine Controls - I6 3.2L Petrol - Engine Coolant Temperature
(ECT) Sensor
Removal and Installation
Removal
• NOTE: Removal steps in this procedure may contain installation details.
Raise and support the vehicle.
1.
Remove the intake manifold assembly.
Refer to:
Intake Manifold
(303-01A Engine - I6 3.2L Petrol, Removal
and Installation).
2.
3. CAUTIONS:
Be prepared to collect escaping fluids.
Note the fitted position of the seal.
Remove the ECT sensor.
3.
Installation
1.
CAUTION: Make sure that the mating faces are clean and
free of foreign material.
To install, reverse the removal procedure.
1.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст