Frelander 2. Manual — part 476
4. NOTE: Do not disassemble further if the component
is removed for access only.
4.
Installation
To install, reverse the removal procedure.
1.
If a new component has been installed, configure using Land Rover
approved diagnostic equipment.
2.
Information and Entertainment System - Audio Unit Antenna
Removal and Installation
Removal
• NOTE: Removal steps in this procedure may contain installation details.
Remove the liftgate upper trim panel.
Refer to:
Liftgate Trim Panel
(501-05 Interior Trim and
Ornamentation, Removal and Installation).
1.
Remove the audio unit antenna.
Torque: 10 Nm
2.
Installation
To install, reverse the removal procedure.
1.
Information and Entertainment System - Satellite Radio Tuner
Removal and Installation
Removal
• NOTE: Removal steps in this procedure may contain installation details.
Remove the LH rear quarter trim panel.
Refer to:
Rear Quarter Trim Panel
(501-05 Interior Trim and
Ornamentation, Removal and Installation).
1.
2.
3. CAUTIONS:
Make sure that the fiber optic cables are not bent
to a radius of less than 25 mm.
Make sure that the optical connectors are clean
and free of foreign material.
Torque: 10 Nm
3.
4. NOTE: Do not disassemble further if the component
is removed for access only.
Torque:
M5 6 Nm
M6 10 Nm
4.
Installation
To install, reverse the removal procedure.
1.
If a new component is to be installed, configure using Land Rover
2.
Information and Entertainment System - Cellular Phone Antenna
Removal and Installation
Removal
• NOTE: Removal steps in this procedure may contain installation details.
Remove both D-pillar upper trim panels.
Refer to:
D-Pillar Trim Panel
(501-05 Interior Trim and
Ornamentation, Removal and Installation).
1.
Release the rear of the headliner.
2.
Torque: 10 Nm
3.
Installation
To install, reverse the removal procedure.
1.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст