Defender. Manual — part 164
32. Remove the parking brake assembly and tie aside.
33. Disconnect the electronic speedometer drive electrical
connector from the transfer gearbox.
34. Remove the nut and disconnect the LH earth cable from
the transfer gearbox.
35. Remove the bolt securing the RH earth cables from the
transfer gearbox.
36. Displace and reposition the high-low detection switch
electrical connector away from the transfer gearbox.
Disconnect the high-low detection switch electrical
connector.
37. Disconnect the differential lock detection switch electrical
connector.
Release the electrical connector from the bracket.
38. Release the breather pipe from transfer gearbox.
Remove the securing bolt.
Remove and discard the 2 sealing washers.
39. Remove the transmission harness retaining bracket
securing nut and bolt and reposition the harness.
40. Release the transmission wiring harness connector and
40. Release the transmission wiring harness connector and
bracket from the RH side of the transmission.
41. Release the transmission wiring harness securing clip
from the LH side of the transmission.
42. Release the transmission wiring harness securing clip
from the RH side of the transmission.
43. Release the transmission wiring harness securing clip
from the top of the transmission.
44. Remove the clutch slave cylinder fluid hose mounting
44. Remove the clutch slave cylinder fluid hose mounting
bracket securing nut and bolt.
Install a suitable pipe clamp to the clutch slave
cylinder fluid hose.
45.
CAUTION: Make sure that all openings are sealed.
Use new blanking caps.
Disconnect the clutch slave cylinder fluid hose from the
clutch slave cylinder.
Remove the clutch slave cylinder line clip.
Remove and discard the O-ring seal.
46. Install the special tool HTJ1200-02 to the transmission and
transfer gearbox.
47. Remove the LH transmission mount and mounting
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст