Defender. Manual — part 221
BJB Link Fuse Descriptions
Item
Number
Rating
(Amps)
Fuse
color
Circuits protected
22
100
Blue
Glow plug relay, fusible links 2,3 and 4, fuses 1,2 and 3 and fuse 36 in the
CJB
21
60
Yellow
CJB Batt feed
20
60
Yellow
Window lift relay
19
30
Green
ABS return pump
18
60
Yellow
Ignition switch/starter relay
17
30
Green
Lighting switch
23
-
-
Main battery power feed
The Battery Junction Box is located under the right front seat and is accessed by removing the seat base.
Battery, Mounting and Cables - Battery Connect
General Procedures
• WARNINGS:
Batteries normally produce explosive gases which may cause personal injury, therefore do not allow lighted
substances to come near the battery. When charging or working near the battery always shield your face and protect
your eyes. Always provide adequate ventilation. Failure to follow these instructions may result in personal injury.
Batteries contain sulphuric acid, avoid contact with skin, eyes or clothing. Shield your face and protect your eyes
when working near the battery to guard against possible splashing of the acid solution. In case of acid contact with the
skin or eyes, flush immediately for a minimum of 15 minutes and seek prompt medical attention. If swallowed, call a
physician immediately. Failure to follow these instructions may result in personal injury.
CAUTION: Make sure all electrical systems are OFF before connecting the battery ground cable. Failure to follow
this instruction may result in damage to the vehicles electrical system.
1. Connect the battery ground cable.
Tighten the nut to 10 Nm (7 lb.ft).
2. Install the battery cover.
Secure with the clip.
3. Install LH front seat cushion.
For additional information, refer to:
Front Seat Cushion
(501-
10 Seating, Removal and Installation).
4. Enter the audio unit keycode and preset radio frequencies.
5. Reset the clock to the correct time.
Battery, Mounting and Cables - Battery Disconnect and Connect
General Procedures
• WARNINGS:
Batteries normally produce explosive gases which may cause personal injury, therefore do not allow lighted
substances to come near the battery. When charging or working near the battery always shield your face and protect
your eyes. Always provide adequate ventilation. Failure to follow these instructions may result in personal injury.
Batteries contain sulphuric acid, avoid contact with skin, eyes or clothing. Shield your face and protect your eyes
when working near the battery to guard against possible splashing of the acid solution. In case of acid contact with the
skin or eyes, flush immediately for a minimum of 15 minutes and seek prompt medical attention. If swallowed, call a
physician immediately. Failure to follow these instructions may result in personal injury.
CAUTION: Make sure the engine is not running before disconnecting the battery ground cable. Failure to follow this
instruction may result in damage to the vehicles electrical system.
• NOTE: This procedure should be used to disconnect the battery while carrying out repairs that refer to the battery
being disconnected.
• NOTE: Before disconnecting the battery make sure that no data is required from the engine control module (ECM), as
battery cable disconnection will erase any fault codes and idle/drive values held in the keep alive memory (KAM).
1. Obtain and record the audio unit keycode and preset radio
frequencies.
2. Remove the LH front seat cushion.
For additional information, refer to:
Front Seat Cushion
(501-
10 Seating, Removal and Installation).
3. NOTE: RH illustration is shown, LH is similar.
Remove the battery cover.
Release the clip.
4.
CAUTION: Failure to follow the procedure below could
result in the alarm sounder self activating when the battery is
disconnected.
Disconnect the battery ground cable.
Loosen the nut.
Turn the ignition key to the run position.
Turn the ignition key to the off position.
Within 17 seconds of turning the ignition key to the off
position, release the battery ground cable from the
battery.
Battery, Mounting and Cables - Battery
Removal and Installation
Removal
1. Remove LH front seat cushion.
2. Release retaining clip and remove battery access cover.
3.
WARNING: During battery removal or before carrying
out any repairs or maintenance to electrical components always
disconnect negative lead first. If positive lead is disconnected
with negative lead in place, accidental contact of a wrench to
any grounded metal part could cause a severe spark, possibly
resulting in personal injury. Upon installation of battery always
connect positive lead first.
Disconnect both battery leads, negative first.
4. Slacken securing nuts and move battery clamp, with 'J' bolts
aside.
5. Remove battery.
Installation
1. NOTE: Coat battery clamps and terminals with petroleum
jelly before refitting.
Position battery and secure with clamp. Ensure 'J' bolts are
hooked correctly under retaining brackets on base of battery
box.
2. Reconnect battery leads, positive lead first.
3. Install battery access cover.
4. Install seat cushion.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст