Defender. Manual — part 298
Rear End Sheet Metal Repairs - Rear Lamp Mounting Panel
Removal and Installation
Removal
1. Disconnect both battery leads, negative lead first.
2. Disconnect generator.
3. Remove rear bench seat.
4. RH side: Remove tail door.
For additional information, refer to:
Taildoor
(501-03 Body
Closures, Removal and Installation).
5. Remove rear lights and reflector.
6. LH side: Remove licence plate and taildoor striker.
Installation
1. Prepare and clean panel joint faces.
2. Reverse removal procedure.
Rear End Sheet Metal Repairs - Rear Quarter Upper Panel
Removal and Installation
Removal
1. Disconnect both battery leads, negative lead first.
2. Remove front, centre and rear sections of headlining.
3. Release upper edge of front door aperture seal.
4. Release upper edge of rear door aperture seal.
5. Remove fixings from front edge of roof, and along side being
replaced.
6. Release sealant securing front edge of roof.
7. Insert wedges into top of both B-pillar and C-pillar. This
will allow access for removal of body side.
8. RH side: Remove tail door.
9. Remove side window.
10. Remove rear sixth light.
11. Remove all bolts securing rear quarter upper panel.
Installation
1. Prepare and clean panel joint faces.
2. NOTE: When refitting, ensure rear quarter upper panel is
correctly fitted onto location pins.
Reverse removal procedure.
Rear End Sheet Metal Repairs - Rear Quarter Lower Panel
Removal and Installation
Removal
• NOTE: In this procedure the bodyside capping and the corner capping are also changed.
1. Disconnect both battery leads, negative lead first.
2. Remove rear quarter upper panel.
For additional information, refer to:
Rear Quarter Upper Panel
(501-30 Rear End Sheet Metal Repairs, Removal and
Installation).
3. Remove all rear lamps and reflectors.
4. LH side: Remove licence plate and lamp.
5. LH side: Remove taildoor striker.
6. RH side: Remove fuel filler and grommet.
7. Remove all bolts and rivets securing rear quarter lower
panel.
Installation
1. Prepare and clean panel joint faces.
2. NOTE: When refitting, ensure rear quarter lower panel is
2. NOTE: When refitting, ensure rear quarter lower panel is
correctly fitted onto location pins.
Reverse removal procedure.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст