Defender. Manual — part 276
3. Tighten to 5 Nm (4 lb.ft).
4. Connect the battery ground cable.
For additional information, refer to:
Battery Connect
(414-01
Battery, Mounting and Cables, General Procedures).
Wipers and Washers - Windshield Wiper/Washer Switch
Removal and Installation
Removal
1. Remove the steering column shrouds.
For additional information, refer to:
Steering Column Shrouds
(501-05 Interior Trim and Ornamentation, Removal and
Installation).
2. Disconnect the electrical connector.
3. Remove and discard the clip.
4. Remove the windshield wiper switch.
Remove the 2 screws.
Installation
1. To install, reverse the removal procedure.
Wipers and Washers - Wiper Mounting Arm and Pivot Shaft
Removal and Installation
Removal
1. Disconnect battery negative lead.
2. Remove steering column shroud.
For additional information, refer to:
Steering Column Shrouds
(501-05 Interior Trim and Ornamentation, Removal and
Installation).
3. Remove windshield wiper motor.
For additional information, refer to:
Windshield Wiper Motor
(501-16 Wipers and Washers, Removal and Installation).
4. Remove 2 screws and move heater fan switch aside.
5. Remove 2 screws securing drivers side demister duct.
6. Disconnect demister tube and remove duct.
7. Remove bolt and nut and bolt securing steering column
support bracket and remove bracket.
8. Remove 11 screws securing fascia support rail.
9. Remove cable ties securing washer tube to windshield wiper
rack tube.
10. Loosen fully 4 nuts securing backplates to wiper mounting
arm and pivot shaft and remove windshield wiper rack tubes.
11. Remove seals from wheel box spindles.
12. Remove 2 nuts securing wiper mounting arm and pivot
12. Remove 2 nuts securing wiper mounting arm and pivot
shaft and remove sealing washers.
13. Carefully pull fascia support rail from bulkhead sufficiently
to remove wiper mounting arm and pivot shaft.
Installation
1. Loosen fully but do not remove nuts securing wheel box back
plates.
2. Grease wiper mounting arm and pivot shaft.
3. Fit wiper mounting arm and pivot shaft, fit sealing washers
and tighten nuts to 5 Nm (3.7 lbf.ft).
4. Fit spindle seals.
5. Fit wiper rack tubes and tighten wiper mounting arm and
pivot shaft nuts sufficiently to hold tubes. Tighten wheel box
back plate nuts to 6 Nm (4 lbf.ft) after fitting windshield
wiper motor.
6. Align washer tube to rack tube and secure with cable ties.
7. Align fascia support rail and secure with screws.
8. Fit steering column support bracket and tighten bolt and nut
and bolt to 45 Nm (33 lbf.ft).
9. Fit demister duct to tube, align relay bracket and secure duct
with screws.
10. Position heater fan switch and secure with screws.
11. Fit windshield wiper motor.
For additional information, refer to:
Windshield Wiper Motor
(501-16 Wipers and Washers, Removal and Installation).
12. Fit steering column shroud.
For additional information, refer to:
Steering Column Shrouds
(501-05 Interior Trim and Ornamentation, Removal and
Installation).
13. Connect battery negative lead.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст