Defender. Manual — part 265
Instrument Panel and Console - In-Vehicle Crossbeam
Removal and Installation
Removal
1. Disconnect the battery ground cable.
For additional information, refer to:
Battery Disconnect and
Connect
(414-01 Battery, Mounting and Cables, General
Procedures).
2. Remove the instrument panel.
For additional information, refer to:
Instrument Panel
(501-12
Instrument Panel and Console, Removal and Installation).
3. NOTE: Make sure the clips are discarded.
Remove the audio unit support bracket.
Remove and discard the 5 clips.
4. Release the steering column bracket.
Remove the bolt.
5. Reposition the steering column bracket.
1. Undo but do not remove the bolt.
2. Reposition the bracket.
6. Remove the in-vehicle crossbeam.
6. Remove the in-vehicle crossbeam.
Remove and discard the 6 nuts.
Installation
1. To install, reverse the removal procedure.
1. Tighten to 23 Nm (17 lb.ft).
2. Tighten to 22 Nm (16 lb.ft).
3. Connect the battery ground cable.
For additional information, refer to:
Battery Connect
(414-01
Battery, Mounting and Cables, General Procedures).
Instrument Panel and Console - Floor Console
Removal and Installation
Removal
1. Remove the cup holder.
2. Open the floor console lid.
3. Remove the floor console.
Remove the 4 screws.
Installation
1. To install, reverse the removal procedure.
Instrument Panel and Console - Instrument Panel Switches
Removal and Installation
Removal
• NOTE: Rear window wiper switch shown, other instrument panel switches similar.
1. Remove the audio unit.
For additional information, refer to:
Audio Unit
(415-01A
Audio Unit, Removal and Installation).
2. Release the instrument panel switch.
3. Remove the instrument panel switch.
Disconnect the electrical connector.
Installation
1. To install, reverse the removal procedure.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст