Range Rover Sport. Manual — part 26
Wheel Bearing and Wheel Hub (64.15.14)
Special Service Tools
Rear wheel bearing remover/installer
204-509/10 (LRT-60-033/10)
Rear wheel bearing remover/installer
205-802/1
Rear wheel bearing remover/installer
205-802/2
Rear wheel bearing remover/installer
205-802/3
Rear wheel bearing remover/installer
205-802/4
Removal
1
.
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle
on safety stands.
Raise and support the vehicle.
2 . Remove the wheel and tire.
3 . Remove the wheel knuckle.
For additional information, refer to
Wheel Knuckle (64.35.10)
4 . Remove the adjuster and return spring.
5 . Remove the primary brake shoe.
Remove the hold-down spring and retaining pin.
Pivot the shoe to release it from the spreader plate and return spring.
7 . Remove the return spring.
8 . Remove the secondary brake shoe.
Remove the hold-down spring and retaining pin.
Disconnect the parking brake cable retaining spring from the brake shoe lever.
9 . Using the special tools, remove the drive flange.
Remove the 3 screws.
11 . Using the special tools, remove the wheel bearing.
Remove the circlip.
Installation
1 . Clean the components.
2 . Using the special tools, install the wheel bearing.
3 .
CAUTION: Make sure that the bearing seal is not damaged when installing the circlip.
Install the circlip.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст