Range Rover Sport. Manual — part 14
Lower Arm Ball Joint (60.15.03)
Special Service Tools
Remover/installer front lower arm ball joint
204-531/3
Remover/installer front lower arm ball joint
204-531/2
Remover/installer front lower arm ball joint
204-531/1
Removal
1
.
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle
on safety stands.
Raise and support the vehicle.
2 . Remove the wheel and tire.
3 . Remove the lower arm.
For additional information, refer to
Lower Arm (60.35.02)
4 . Remove the circlip.
Installation
1 . Clean the components.
2 . Using the special tools, install the ball joint.
3 . Install the circlip.
4 . Install the lower arm.
For additional information, refer to
Lower Arm (60.35.02)
5 . Install the wheel and tire.
Tighten the wheel nuts to 140 Nm (103 lb.ft).
Wheel Knuckle (60.25.01)
Special Service Tools
Halfshaft remover/replacer
204-506/1 (LRT-60-030/1)
Halfshaft remover/replacer
204-506/2(LRT-60-030/2)
Halfshaft remover/replacer
204-506/3 (LRT-60-030/3)
Retainers - halfshaft remover/replacer
204-506/5 (LRT-60-030/5)
Halfshaft installer adapter
204-506-01
Removal
All vehicles
1
.
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle
on safety stands.
Raise and support the vehicle.
2 . Remove the wheel and tire.
3 . Loosen the halfshaft retaining nut.
Vehicles with standard brakes
4 . Remove the brake disc.
For additional information, refer to
Brake Disc - Vehicles Without: Brembo Brakes (70.12.10)
Vehicles with high performance brakes
5 . Remove the brake disc.
For additional information, refer to
Brake Disc - Vehicles With: Brembo Brakes (70.12.10)
All vehicles
6 . Remove the halfshaft retaining nut.
Discard the nut.
7 . Loosen the tie-rod end ball joint retaining nut.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст