Freelander Body Repair Manual — part 60
PANEL REPAIRS
SEALING AND CORROSION PROTECTION
25
Seam sealer on vehicle interior and rear quarter - 3 door
Seams symmetrically opposite to those shown are also treated. Sealant to be wiped to a smooth finish over length
’A’ (rear load floor to rear heelboard underframe).
PANEL REPAIRS
26
SEALING AND CORROSION PROTECTION
Seam sealer on vehicle interior and rear quarter - 5 door
Seams symmetrically opposite to those shown are also treated. Sealant to be wiped to a smooth finish over length
’A’ (rear load floor to rear heelboard underframe).
PANEL REPAIRS
SEALING AND CORROSION PROTECTION
27
SOUND DAMPENING
During production, expanded foam is incorporated
into some body cavities to reduce noise or prevent
the ingress of moisture, dust and fumes. After a
repair that involves replacement of a section
containing expanded foam, the new section must be
injected with an approved sound dampening foam.
See INFORMATION, Sealing and corrosion
protection. The sound dampening foam should be
injected after paint refinishing and application of
cavity wax.
Accessible cavities that must be injected with sound
dampening foam are detailed in the following
Figures. When injecting the foam, ensure the foam
fills a complete cross section of the cavity.
Sound dampening foam injection points - 3 door
Cavities symmetrically opposite to those shown must also be treated.
1. ’A’ post reinforcement to sill
reinforcement/inner sill
2. ’B’ post reinforcement to sill
reinforcement/inner sill
3. End of rear lower body closing assembly -
inject through either hole, angle applicator
nozzle to fill outboard end of assembly
PANEL REPAIRS
28
SEALING AND CORROSION PROTECTION
Sound dampening foam injection points - 5 door
Cavities symmetrically opposite to those shown must also be treated.
1. ’A’ post reinforcement to sill
reinforcement/inner sill
2. ’B/C’ post reinforcement to sill
reinforcement/inner sill
3. Outer wheelarch to outer body side
4. End of rear lower body closing assembly -
inject through either hole, angle applicator
nozzle to fill outboard end of assembly
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст