Harley Davidson 2003 VRSCA model. Service manual — page 17

CAM DRIVE
ASSEMBLY
1. Rotate the front cylinder piston to TDC. Remove plug from timing hole on right side of engine and insert CRANKSHAFT LOCKING PIN (HD-45306).The CRANKSHAFT LOCKING PIN should insert flush with engine case.

2. See Figure 3-236. Insert water pump shaft through case until flush with case on cam drive side.

3. See Figure 3-237. Position triple gear on water pump shaft and drive chain on crankshaft drive gear. Squeeze drive chain to simulate the chain position with the chain tensioners in place. Walk chain around crankshaft gear to change position.

4. See Figure 3-238. Install primary chain fixed tensioner. Note the flat in the chain tensioner bore and the flat on the mounting shaft in the case.

FUEL SYSTEM
SUBJECT PAGE NO.

4.1 Specifications . . . . . . . . . . . . . . . . . . . . . . . . ..4-1

4.2 Fuel Pump/Filters/Fuel Level Sender Assembly. . . . . . . . . . . ..4-2

4.3 Fuel Tank. . . . . . . . . . . . . . . . . . . . . . . . . . ..4-7

4.4 Vapor Valve. . . . . . . . . . . . . . . . . . . . . . . . . ..4-9

4.5 Evaporative Emissions Control-CA Models. . . . . . . . . . . . . ..4-10