Jeep Grand Cherokee WK. Manual — part 38
CV BOOT-OUTER
REMOVAL
NOTE: CV joint is serviced with the shaft, the boot
can be serviced separately
1. Remove inner CV boot and joint.
2. Cut outer CV boot (5) clamps (2) (4).
3. Cut boot off CV housing (1) and shaft (3).
INSTALLATION
1. Clean the CV joint then apply new grease to the
joint.
2. Slid the new boot (5) on to the shaft (3) and on the
CV housing (1).
3. Install boot clamps (2) (4) in original locations.
4. Install inner CV joint and boot,
3 - 50
HALF SHAFT
WK
CV JOINT/BOOT-INNER
REMOVAL
1. Clamp shaft in a vise (with soft jaws) and support
C/V joint (1).
2. Remove clamps with a cut-off wheel or grinder.
3. Slide boot down (2) the shaft.
4. Remove lubricant from housing (1) to expose the
C/V snap ring (2) and remove snap ring.
WK
HALF SHAFT
3 - 51
5. Remove bearings (4) from the cage (1).
6. Rotate cage (1) 30° and slide cage off the inner
race (2) and down the shaft (3).
7. Remove spread inner race (1) snap ring (4) and
remove race (1) from the shaft (3).
8. Remove boot from the shaft and discard.
3 - 52
HALF SHAFT
WK
9. Clean and inspect housing (1), cage (2), bearings
(3), housing snap-ring (4), inner race snap-ring (5)
and inner race (6) for wear or damage.
INSTALLATION
1. Apply a coat of grease supplied with the joint/boot
to the C/V joint components before assembling
them.
2. Place new clamps on the new boot and slide boot
down the shaft.
3. Slide cage (2) onto the shaft (1) with the small
diameter (3) end towards the boot.
WK
HALF SHAFT
3 - 53
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст