Jeep Grand Cherokee WK. Manual — part 1228
9. Identify rod bearing caps before removal. Remove rod bearing caps with bearings.
10. Identify main bearing caps (1) before removal.
11. Remove main bearing caps (1) and bearings one
at a time.
9 - 1508
ENGINE - 5.7L SERVICE INFORMATION
WK
12. Remove the thrust washers.
13. Remove the crankshaft out of the block.
INSTALLATION
WK
ENGINE - 5.7L SERVICE INFORMATION
9 - 1509
1. Select the proper main bearings (Refer to 9 -
ENGINE/ENGINE
BLOCK/CRANKSHAFT
MAIN
BEARINGS - STANDARD PROCEDURE).
2. Install main bearings in block and caps, and lubri-
cate bearings.
3. Position the crankshaft into the cylinder block.
4. Install the thrust washers (1).
9 - 1510
ENGINE - 5.7L SERVICE INFORMATION
WK
NOTE: The main cap crossbolts are torqued after final torque of the main cap bolts. Always use a new
washer/seal on crossbolts.
5. Clean and oil all cap bolts. Install all main bearing caps (1). Install all cap bolts and alternately tighten in two
steps using the following sequence.
6.
•
Step 1 – 27 N·m ( 20ft. lbs.) torque.
7.
•
Step 2 – Turn main cap bolts an additional 90°.
8. Install the crossbolts with new washer/gasket.
Starting with crossbolt A torque each crossbolt to
28 N·m ( 21ft. lbs.)torque.
9. Repeat crossbolt torque procedure.
10. Measure crankshaft end play (Refer to 9 -
ENGINE/ENGINE BLOCK/CRANKSHAFT MAIN
WK
ENGINE - 5.7L SERVICE INFORMATION
9 - 1511
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст