Jeep Grand Cherokee WK. Manual — part 1627
4. Squeeze the lower support wires (1) in and release
the lower wires.
5. Pull the upper support wires (1) down and release
the lumbar mat from the seat back frame.
6. Remove the rivet (1) and remove the lumbar mech-
anism (2).
23 - 166
SEATS
WK
INSTALLATION
1. Before proceeding with the following repair proce-
dure, review all warnings and cautions. (Refer to
23 - BODY/SEATS - WARNING)
2. Install the lumbar mechanism (2) and install a new
rivet (1).
3. Place lumbar mat onto seat back frame and insert
the upper support wires (1) into the frame.
4. Squeeze the lower support wires (1) together and
insert into the lower frame.
WK
SEATS
23 - 167
5. Squeeze the side support wires together and insert
them into the sides of the seat back frame.
6. Install the seat back cushion/cover. (Refer to 23 -
BODY/SEATS/SEAT BACK CUSHION / COVER -
FRONT - INSTALLATION)
23 - 168
SEATS
WK
STATIONARY GLASS
TABLE OF CONTENTS
page
page
STATIONARY GLASS
QUARTER GLASS
. . . . . . . . . . . . . . . . . . . . . . . . . . . . 170
. . . . . . . . . . . . . . . . . . . . . . . . 170
WINDSHIELD
. . . . . . . . . . . . . . . . . . . . . . . . 171
. . . . . . . . . . . . . . . . . . . . . . . . . . . . 171
. . . . . . . . . . . . . . . . . . . . . . . . 171
STATIONARY GLASS
WARNING
WINDSHIELD SAFETY PRECAUTIONS
WARNING: Do not operate the vehicle within 24 hours of windshield installation. It takes at least 24 hours
for urethane adhesive to cure. If it is not cured, the windshield may not perform properly in an accident.
•
Urethane adhesives are applied as a system. Use glass cleaner, glass prep solvent, glass primer, pvc
(vinyl) primer and pinch weld (fence) primer provided by the adhesive manufacturer. If not, structural
integrity could be compromised.
•
Daimlerchrysler does not recommend glass adhesive by brand. Technicians should review product labels
and technical data sheets, and use only adhesives that their manufactures warrant will restore a vehicle
to the requirements of fmvss 212. Technicians should also insure that primers and cleaners are compat-
ible with the particular adhesive used.
•
Be sure to refer to the urethane manufacturer’s directions for curing time specifications, and do not use
adhesive after its expiration date.
•
Vapors that are emitted from the urethane adhesive or primer could cause personal injury. Use them in a
well-ventilated area.
•
Skin contact with urethane adhesive should be avoided. Personal injury may result.
•
Always wear eye and hand protection when working with glass.
WK
STATIONARY GLASS
23 - 169
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст