Jeep Grand Cherokee WK. Manual — part 1375
7. Remove the exhaust support bracket from the rear
of the transmission.
8. Disconnect and lower or remove any necessary
exhaust components.
9. Remove the starter motor.
10. Rotate crankshaft in clockwise direction until con-
verter bolts are accessible. Then remove bolts
one at a time. Rotate crankshaft with socket
wrench on dampener bolt.
11. Disconnect the input speed sensor (2) connector.
12. Disconnect
the
output
speed
sensor
(2)
connector.
13. Disconnect the solenoid and pressure switch
assembly (2) connector.
21 - 310
AUTOMATIC TRANSMISSION - 545RFE - SERVICE INFORMATION
WK
14. Disconnect the line pressure sensor (2) connector.
15. Disconnect gearshift cable (3) from transmission
manual valve lever (2) and shift cable bracket (4).
16. If necesary, remove the NV140 transfer case (1)
from the transmission (3). (Refer to 21 - TRANS-
MISSION/TRANSFER CASE - REMOVAL)
WK
AUTOMATIC TRANSMISSION - 545RFE - SERVICE INFORMATION
21 - 311
17. If necesary, remove the NV245 transfer case (1)
from the transmission (3). (Refer to 21 - TRANS-
MISSION/TRANSFER CASE - REMOVAL)
18. Remove the engine oil pan to transmission bolts
(1), 5.7L only.
21 - 312
AUTOMATIC TRANSMISSION - 545RFE - SERVICE INFORMATION
WK
19. Remove the bolt (4) holding the transmission fill
tube (2) to the transmission (1) and remove the fill
tube and dipstick (3).
20. Disconnect transmission fluid cooler lines (2) at
transmission (1) fittings and clips. (Refer to 7 -
COOLING/TRANSMISSION/TRANS
COOLER
-
STANDARD PROCEDURE)
21. Disconnect the transmission vent hose from the
transmission.
22. Support rear of engine with safety stand or jack.
23. Raise transmission slightly with service jack to
relieve load on crossmember and supports.
24. Remove bolts attaching crossmember to frame
and remove crossmember.
25. Remove all remaining transmission (2) to engine
(1) bolts (3).
WK
AUTOMATIC TRANSMISSION - 545RFE - SERVICE INFORMATION
21 - 313
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст