Jeep Grand Cherokee WK. Manual — part 1286
2. Tighten the two screws (1) securing the SCM (3) to
the column shaft housing.
3. Connect the two electrical connectors (3 & 4) to the
SCM (2).
19 - 58
COLUMN - SERVICE INFORMATION
WK
4. Install the steering column shrouds (1 & 2) (Refer
to
19
-
STEERING/COLUMN/SHROUD
-
INSTALLATION).
5. Align the spline on the steering wheel hub to shaft
(5) and install the steering wheel (3). (Refer to 19 -
STEERING/COLUMN/STEERING
WHEEL
-
INSTALLATION).
6. Install a NEW retaining bolt (4). Torque the bolt to
61 N·m (45 ft. lbs.).
7. Install the driver airbag (Refer to 8 - ELECTRICAL/
RESTRAINTS/DRIVER AIRBAG - INSTALLATION).
8. Connect the battery negative cable.
NOTE: IF EQUIPPED WITH ESP - recalibrate the
steering angle sensor using the scan tool (Refer to
8 - ELECTRICAL/BATTERY SYSTEM - STANDARD
PROCEDURE).
WK
COLUMN - SERVICE INFORMATION
19 - 59
GEAR - SERVICE INFORMATION
TABLE OF CONTENTS
page
page
GEAR - SERVICE INFORMATION
. . . . . . . . . . . . . . . . . . . . . . . . . 60
. . . . . . . . . . . . . . . . . . . . . . . . . . . 60
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 60
. . . . . . . . . . . . . . . . . . . . . . . . . 63
. . . . . . . . . . . . . . . . . . . . . . 66
GEAR - SERVICE INFORMATION
DESCRIPTION
A rack and pinion steering gear is made up of two
main components, the pinon shaft and the rack. The
gear cannot be adjusted or internally serviced. If a
malfunction or a fluid leak occurs, the gear must be
replaced as an assembly.
OPERATION
The steering column intermediate shaft is attached to the gear pinion. The rotation of the pinion moves the gear
rack from side-to-side. This lateral action of the rack pushes and pulls the tie rods, which are connected to the
steering knuckles to change the direction of the front wheels.
REMOVAL
1. Place the front wheels in the straight ahead posi-
tion with the steering wheel centered and locked
with a steering wheel lock.
2. Drain or siphon the power steering system.
3. Remove the column coupler shaft bolt (2) and
remove the shaft from the gear (3).
19 - 60
GEAR - SERVICE INFORMATION
WK
4. Remove the oil drip tray (1).
5. Remove the pressure line (2) at the gear (1).
6. Remove the return line (3) at the gear (1).
7. Raise and support the vehicle.
8. Remove the front tires.
WK
GEAR - SERVICE INFORMATION
19 - 61
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст