Jeep Grand Cherokee WK. Manual — part 56
6. Install half shaft into axle and knuckles. Verify axle
are engaged in the axle.
7. Install clevis (3) bolt and nut (4) on lower control
arms and tighten to specification.
8. Install upper control arms on knuckles and tighten
ball joint nuts to specifications.
9. Install tie rod ends (4) and nuts (5) on knuckles
and tighten to specifications.
10. Install stabilizer bar links (2) and bolts (6) on
lower control arms and tighten to specifications.
3 - 122
FRONT AXLE - C200FE
WK
11. Install brake calipers on knuckles.
12. Install wheel speed sensor (1) on hub/bearing (3).
13. Install half shaft hub nuts and tighten to 135 N·m
(100 ft. lbs.).
14. Install propeller shaft on pinion flange with refer-
ence marks aligned.
15. Install drain plug and tighten to 60 N·m (44 ft.
lbs.).
16. Fill differential housing and install fill plug. Tighten
plug to 60 N·m (44 ft. lbs.).
17. Install skid plate.
ADJUSTMENTS
ADJUSTMENT
PINION DEPTH MEARSUREMENT
NOTE:
Take
measurement
with
pinion
shim
removed and rear bearing cup in place.
1. Install Pinion Height Block 6739 (3), Pinion Block
9534 (2), and pinion head bearing cone (1) onto
Screw 6741. Install assembly into axle housing and
through bearing and cups.
2. Install pinion front bearing and Cone 6740. Tighten
Cone 6740 by hand until 3.4 N·m (30 in. lbs.) of
rotating torque is measured at Screw 6741.
WK
FRONT AXLE - C200FE
3 - 123
3. Install Arbor Discs 9538 (1) and Arbor Bar D-115-3
(2).
4. Install Dial Indicator 9524 (1) to Scooter Block
D-115-2A (2). Secure with set-screw (3).
3 - 124
FRONT AXLE - C200FE
WK
5. Install Indicator/Block assembly to top of Height
Block 6739 (1). Zero indicator on top surface.
6. Slide indicator probe off of height block and onto
Arbor Bar D-115-3 (2). As indicator contacts Arbor
Bar (2), indicator needle will rotate clockwise. Con-
tinue moving indicator probe to the crest of the
arbor bar and record the highest reading. Then add
4 mm (0.157 in.) to the recorded reading. This will
give you the correct shim selection for pinion
height.
DIFFERENTIAL SIDE BEARING PRELOAD
Differential side bearing preload is predetermined. The select snap rings in the differential housing will provide the
correct differential side bearing preload. These snap can be adjusted to obtain the correct ring gear backlash mea-
surement.
WK
FRONT AXLE - C200FE
3 - 125
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст