Jeep Grand Cherokee WK. Manual — part 262
DIAGNOSIS AND TESTING
MODULE - ANTENNA
ANTENNA MODULE DIAGNOSIS TABLE
CONDITION
POSSIBLE CAUSES
CORRECTION
NO AM RECEPTION,
WEAK FM RECEPTION
1. Antenna module to antenna
connector open or disconnected.
1. Repair open, reconnect
antenna module connector to
glass mounted antenna.
2. Coax open or disconnected.
2. Repair open, reconnect coax.
3. No battery power at antenna
module.
3. Check fuse. if okay, repair
open in battery voltage circuit.
NO AM OR FM
RECEPTION
1. Coax disconnected at radio.
1. Reconnect coax.
2. Coax shorted to ground.
2. Repair or Replace coax
WEAK OR NO AM/FM
RECEPTION
1. Antenna Module inoperative.
1. Substitute a known good
module to see If reception
improves. Replace antenna
module as necessary.
REMOVAL
WARNING:
DISABLE
THE
AIRBAG
SYSTEM
BEFORE ATTEMPTING ANY STEERING WHEEL,
STEERING COLUMN, SEAT BELT TENSIONER,
SIDE AIRBAG, OR INSTRUMENT PANEL COMPO-
NENT DIAGNOSIS OR SERVICE. DISCONNECT
AND
ISOLATE
THE
BATTERY
NEGATIVE
(GROUND) CABLE, THEN WAIT TWO MINUTES
FOR THE AIRBAG SYSTEM CAPACITOR TO DIS-
CHARGE BEFORE PERFORMING FURTHER DIAG-
NOSIS OR SERVICE. THIS IS THE ONLY SURE
WAY TO DISABLE THE AIRBAG SYSTEM. FAILURE
TO TAKE THE PROPER PRECAUTIONS COULD
RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT
AND POSSIBLE PERSONAL INJURY.
1. Disconnect and isolate the battery negative cable.
2. Lower the right side of the headliner.
3. Disconnect the antenna module connector from the
integral antenna.
4. Remove the mounting fasteners and the antenna
module.
5. Disconnect the battery power lead connector from
the antenna module.
6. Disconnect
the
coax
lead
from
the
antenna
module.
8A - 184
AUDIO/VIDEO - SERVICE INFORMATION
WK
INSTALLATION
WARNING:
DISABLE
THE
AIRBAG
SYSTEM
BEFORE ATTEMPTING ANY STEERING WHEEL,
STEERING COLUMN, SEAT BELT TENSIONER,
SIDE AIRBAG, OR INSTRUMENT PANEL COMPO-
NENT DIAGNOSIS OR SERVICE. DISCONNECT
AND
ISOLATE
THE
BATTERY
NEGATIVE
(GROUND) CABLE, THEN WAIT TWO MINUTES
FOR THE AIRBAG SYSTEM CAPACITOR TO DIS-
CHARGE BEFORE PERFORMING FURTHER DIAG-
NOSIS OR SERVICE. THIS IS THE ONLY SURE
WAY TO DISABLE THE AIRBAG SYSTEM. FAILURE
TO TAKE THE PROPER PRECAUTIONS COULD
RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT
AND POSSIBLE PERSONAL INJURY.
1. Connect antenna cable to antenna module.
2. Connect battery power supply lead to antenna
module.
3. Position antenna module onto right side upper roof
rail. Install and tighten mounting fasteners.
4. Connect antenna module lead to the integral
antenna.
5. Install headliner.
MONITOR-MEDIA SYSTEM
DESCRIPTION
The video entertainment system, consist of:
•
Battery powered remote control
•
DVD player located at the end of the center
floor console
•
Two headsets
•
Video monitor (3) located on the head-
liner (2)
In addition to video DVDs, the system will
play audio DVDs, audio CDs, MP3 audio
disc, and video CDs. There are plug-in
jacks on the DVD player to show video
directly from a video camera, connect video
games for display on the screen, and play
music directly from a MP3 player.
WK
AUDIO/VIDEO - SERVICE INFORMATION
8A - 185
OPERATION
A seven inch (diagonal measurement) liquid crystal display (LCD) screen supports both 3 X 4 and 6 X 9 video
formats. The hinged screen latches in the closed position and swings down for viewing.
REMOVAL
WARNING:
DISABLE
THE
AIRBAG
SYSTEM
BEFORE ATTEMPTING ANY STEERING WHEEL,
STEERING COLUMN, SEAT BELT TENSIONER,
SIDE AIRBAG, OR INSTRUMENT PANEL COMPO-
NENT DIAGNOSIS OR SERVICE. DISCONNECT
AND
ISOLATE
THE
BATTERY
NEGATIVE
(GROUND) CABLE, THEN WAIT TWO MINUTES
FOR THE AIRBAG SYSTEM CAPACITOR TO DIS-
CHARGE BEFORE PERFORMING FURTHER DIAG-
NOSIS OR SERVICE. THIS IS THE ONLY SURE
WAY TO DISABLE THE AIRBAG SYSTEM. FAILURE
TO TAKE THE PROPER PRECAUTIONS COULD
RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT
AND POSSIBLE PERSONAL INJURY.
1. Disconnect and isolate the battery negative cable.
2. Remove the two mounting fasteners.
3. Using a trim stick, press the retaining clip at the
rear of the monitor (3). Move the monitor from side
to side to release from headliner (2).
4. Disconnect electrical harness connector (1) and
remove monitor.
INSTALLATION
1. Connect electrical harness connector (1) to monitor
(3).
2. Position monitor and press into place.
3. Install and tighten mounting fasteners.
4. Connect battery negative cable.
8A - 186
AUDIO/VIDEO - SERVICE INFORMATION
WK
PLAYER - DVD
DESCRIPTION
The video entertainment system, consist of:
•
Battery powered remote control
•
DVD player located at the end of the center
floor console
•
Two headsets
•
Video monitor located on the headliner
In addition to video DVDs, the system will
play audio DVDs, audio CDs, MP3 audio
disc, and video CDs. There are plug-in
jacks on the DVD player to show video
directly from a video camera, connect video
games for display on the screen, and play
music directly from a MP3 player.
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Using a trim stick, gently pry on the sides of the
DVD player and separate from console.
3. Disconnect electrical harness connector from DVD
player.
WK
AUDIO/VIDEO - SERVICE INFORMATION
8A - 187
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст