Jeep Grand Cherokee WK. Manual — part 446
FOG LAMP ADJUSTMENT
A properly aligned fog lamp will project a pattern on the alignment screen 100 mm (4 in.) below the fog lamp cen-
terline and straight ahead.
Rotate the adjustment screw (1) to adjust beam height
(2).
HEADLAMP
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the headlamp unit (Refer to 8 - ELECTRI-
CAL/LAMPS/LIGHTING - EXTERIOR/HEADLAMP
UNIT - REMOVAL).
8L - 94
LAMPS/LIGHTING - EXTERIOR - SERVICE INFORMATION
WK
3. Turn the high or low beam lamp (1 or 2) one quar-
ter turn counter clockwise.
4. Disconnect the electrical connector from lamp.
INSTALLATION
CAUTION: Do not touch the bulb glass with fin-
gers or other oily surfaces. Reduced bulb life will
result.
1. Position the high or low beam lamp (1 or 2) into
the head lamp unit (5).
2. Position the lamp (1 or 2) in headlamp unit (5) and
turn the lamp one quarter turn clockwise.
3. Connect the lamp (1 or 2) electrical connector.
WK
LAMPS/LIGHTING - EXTERIOR - SERVICE INFORMATION
8L - 95
4. Install the headlamp unit (Refer to 8 - ELECTRI-
CAL/LAMPS/LIGHTING - EXTERIOR/HEADLAMP
UNIT - INSTALLATION).
HEADLAMP UNIT
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the headlamp cover (1).
8L - 96
LAMPS/LIGHTING - EXTERIOR - SERVICE INFORMATION
WK
3. Remove the mounting fasteners.
4. Disconnect the headlamp unit electrical connector
(4).
5. Separate the headlamp from vehicle.
INSTALLATION
CAUTION: Do not touch the bulb glass with fin-
gers or other oily surfaces. Reduced bulb life will
result.
NOTE: If installing a new headlamp unit, transfer
all the wiring, bulbs, and sockets to the new unit.
1. Install all of the bulb sockets in headlamp (1).
2. Position the headlamp on the vehicle.
3. Connect the electrical connector (4).
4. Push the headlamp inward to secure into position.
5. Install mounting fasteners (2 & 3).
WK
LAMPS/LIGHTING - EXTERIOR - SERVICE INFORMATION
8L - 97
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст