Jeep Grand Cherokee WK. Manual — part 534
INSTALLATION
WARNING: A seat structure that has seen signifi-
cant load may have the locking mechanism acti-
vated and may exhibit the following symptoms:
•
Locking pawl (2) loose
•
Locking pawl (2) engaged into the seat frame
sidemember (1)
•
Height adjuster only works on outboard side
•
Broken or missing shear pin (3)
If any one or more of these symptoms exist
replace the height adjuster assembly. Do not
attempt
any
repairs.
Failure
to
follow
these
instructions may result in personal injury or death.
FRONT TILT MOTOR
1. Position motor (1) on seat adjuster (2).
8N - 296
POWER SEATS - SERVICE INFORMATION
WK
2. Install the fasteners (1) holding the motor to the
seat adjuster (2). Tighten the screws to 5 N·m (44
in. lbs.).
3. Connect the motor electrical connector.
4. Install the seat cushion (Refer to 23 - BODY/
SEATS/SEAT CUSHION
COVER
-
INSTALLA-
TION).
5. Clip the wire harness to cushion pan.
6. Install the seat assembly (Refer to 23 - BODY/
SEATS/SEAT - INSTALLATION).
7. Connect the battery negative cable.
8. Verify
normal
operation
of
the
power
seat
assembly.
WK
POWER SEATS - SERVICE INFORMATION
8N - 297
HEIGHT ADJUST MOTOR
1. Ensure the seat adjuster (2) is in the full up posi-
tion by pulling upward on the upper adjuster
assembly.
2. Position motor (3) on seat adjuster (2).
3. Install the motor shaft screw and washer and
tighten until snug. Do not torque screw at this
time.
4. Install the screws (1) holding the motor (3) to the
seat adjuster (2). It may be necessary to twist
the motor slightly to align the fastener holes.
5. Starting with the bottom screw, tighten the motor
screws (1) to 9 N·m (80 in. lbs.).
6.
Tighten the motor shaft screw and washer to 6.5
N·m (57.5 in. lbs.).
8N - 298
POWER SEATS - SERVICE INFORMATION
WK
7. Connect the motor electrical connector.
8. Install the seat cushion (Refer to 23 - BODY/
SEATS/SEAT CUSHION
COVER
-
INSTALLA-
TION).
9. Clip the wire harness to cushion pan.
10. Install the seat assembly (Refer to 23 - BODY/
SEATS/SEAT - INSTALLATION).
11. Connect the battery negative cable.
12. Verify
normal
operation
of
the
power
seat
assembly.
POWER SEAT RECLINER
REMOVAL
1. Remove the seat back frame assembly (Refer to
23 - BODY/SEATS/SEAT BACK CUSHION/COVER
- REMOVAL).
2. Remove any parts that will need to be installed on
new seat back frame assembly.
WK
POWER SEATS - SERVICE INFORMATION
8N - 299
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст