Jeep Grand Cherokee WK. Manual — part 1126
U0141-LOST COMMUNICATION WITH FRONT CONTROL MODULE
9 - 1100
ENGINE ELECTRICAL DIAGNOSTICS
WK
U0141-LOST COMMUNICATION WITH FRONT CONTROL MODULE (CONTINUED)
For a complete wiring diagram Refer to Section 8W.
•
When Monitored:
Ignition run time is greater than 1 second. Battery voltage between 9 and 16 volts.
•
Set Condition:
The PCM doesn’t receive a FCM message over the CAN C circuit for 7 consecutive seconds. The circuit is
continuously monitored.
Possible Causes
CAN C BUS OPEN OR SHORTED CONDITION
FRONT CONTROL MODULE
PCM
Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES - DIAGNOSIS AND TESTING for diagnostic
procedures and for further possible causes.
Diagnostic Test
1.
ACTIVE DTC
Ignition on, engine not running.
With a scan tool, read PCM DTCs.
Is the DTC active at this time?
Yes
>> Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES - DIAGNOSIS AND TESTING for diag-
nostic procedures and for further possible causes.
No
>> Refer to the INTERMITTENT CONDITION Diagnostic Procedure.
Perform the POWERTRAIN VERIFICATION TEST. (Refer to 9 - ENGINE - STANDARD PROCEDURE)
WK
ENGINE ELECTRICAL DIAGNOSTICS
9 - 1101
U0155-LOST COMMUNICATION WITH CLUSTER
9 - 1102
ENGINE ELECTRICAL DIAGNOSTICS
WK
U0155-LOST COMMUNICATION WITH CLUSTER (CONTINUED)
For a complete wiring diagramRefer to Section 8W.
•
When Monitored:
Ignition run time is greater than 1 second. Battery voltage between 9 and 16 volts. Engine run time greater
than 3 seconds.
•
Set Condition:
The PCM doesn’t receive a Cluster message over the CAN C circuit for 7 consecutive seconds. The circuit is
continuously monitored.
Possible Causes
CAN C BUS OPEN OR SHORTED CONDITION
CLUSTER
FCM
PCM
Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES - DIAGNOSIS AND TESTING for diagnostic
procedures and for further possible causes.
Diagnostic Test
1.
ACTIVE DTC
Ignition on, engine not running.
With a scan tool, read PCM DTCs.
Is the DTC active at this time?
Yes
>> Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES - DIAGNOSIS AND TESTING for diag-
nostic procedures and for further possible causes.
No
>> Refer to the INTERMITTENT CONDITION Diagnostic Procedure.
Perform the POWERTRAIN VERIFICATION TEST. (Refer to 9 - ENGINE - STANDARD PROCEDURE)
WK
ENGINE ELECTRICAL DIAGNOSTICS
9 - 1103
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст