Jeep Grand Cherokee WK. Manual — part 11
SPECIAL TOOLS
FRONT SUSPENSION
PULLER - 8677
CLEVIS BUSHING - 9653
BALL JOINT - 9654
BALL JOINT - C-4212-3
2 - 8
FRONT
WK
BUSHINGS
DESCRIPTION
Suspension components with rubber/urethane bushings should be tightened with the vehicle at normal ride height.
It is important to have the springs supporting the weight of the vehicle when the fasteners are torqued. If springs are
not at their normal ride position, vehicle ride comfort could be affected and premature bushing wear may occur.
REMOVAL
STABILIZER BAR TO FRAME BUSHING
1. Raise and support the vehicle.
2. Remove the front splash shield.
3. Remove the two stabilizer barretainer bracket bolts
(2).
4. Remove the bushing clamp (2).
5. Remove the stabilizer bar bushing (3).
CLEVIS BRACKET BUSHING
1. Remove the clevis bracket (3) from the shock (1)
(Refer
to
2
-
SUSPENSION/FRONT/CLEVIS
BRACKET - REMOVAL).
WK
FRONT
2 - 9
NOTE: Extreme pressure lubrication must be used
on the threaded portions of the tool. This will
increase the longevity of the tool and insure
proper operation during the removal and installa-
tion process.
2. Press the bushing out using special tools C-4212-F
(Press)
(1),
9653–1
(driver)
(4)
and
9653–2
(Receiver) (2) from the lower control arm (3).
INSTALLATION
STABILIZER BAR TO FRAME BUSHING
1. Install the stabilizer bar bushing (3) to the bar (1).
2. Install the stabilizer bar bushing reatainer bracket
(2) bolts and tighten the two mounting bolts.
3. Install the front splash shield.
4. Lower the vehicle.
2 - 10
FRONT
WK
CLEVIS BRACKET BUSHING
NOTE: Extreme pressure lubrication must be used
on the threaded portions of the tool. This will
increase the longevity of the tool and insure
proper operation during the removal and installa-
tion process.
1. Install the new clevis bracket bushing (3) into the
lower control arm (5) using tools C-4212-F (Press)
(1), 9653–3 (driver) (2), 9653–4 (Depth gauge) (4)
the depth gauge will automatically set the depth of
the bushing (3) in the control arm (5).
2. Install the clevis bracket (3) to the shock (1) (Refer
to 2 - SUSPENSION/FRONT/CLEVIS BRACKET -
INSTALLATION).
HUB / BEARING
DESCRIPTION
The bearing used on the front hub of this vehicle is the combined hub and bearing unit type assembly. This unit
assembly combines the front wheel mounting hub (flange) and the front wheel bearing into a one piece unit. The
wheel mounting studs are the only replaceable component of the hub/bearing assembly.
OPERATION
The hub/bearing assembly is mounted to the steering knuckle and is retained by three mounting bolts accessible
from the back of the steering knuckle. The hub/bearing unit is not serviceable and must be replaced as an assembly
if the bearing or the hub is determined to be defective.
WK
FRONT
2 - 11
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст