Jeep Grand Cherokee WK. Manual — part 1542
C230A-NEUTRAL INDICATOR CONTROL CIRCUIT LOW
21 - 978
TRANSFER CASE - ELECTRICAL DIAGNOSTICS
WK
C230A-NEUTRAL INDICATOR CONTROL CIRCUIT LOW (CONTINUED)
For a complete wiring diagram Refer to Section 8W
•
When Monitored:
With the ignition on and no system undervoltage or overvoltage condition present.
•
Set Condition:
The Final Drive Control Module detects low voltage on the Neutral Indicator Control Circuit when output is off.
Possible Causes
INTERMITTENT NEUTRAL INDICATOR CONTROL CIRCUIT LOW
(G95) 4WD NEUTRAL INDICATOR CIRCUIT OPEN
(G95) 4WD NEUTRAL INDICATOR CIRCUIT SHORTED TO GROUND
TRANSFER CASE SELECTOR SWIITCH
FINAL DRIVE CONTROL MODULE
Diagnostic Test
1.
DTC IS ACTIVE
Ignition on.
With the scan tool, select View DTCs.
Is the status Active for this DTC?
Yes
>> Go to 2
No
>> Go to 7
2.
(G95) 4WD NEUTRAL INDICATOR CIRCUIT RESISTANCE TO GROUND
Turn the ignition off.
Disconnect the Final Drive Control Module C2 connector.
Measure the resistance between ground and the (G95) 4WD Neutral
Indicator circuit.
Is the resistance below 5.0 ohms?
Yes
>> Go to 3
No
>> Go to 4
WK
TRANSFER CASE - ELECTRICAL DIAGNOSTICS
21 - 979
C230A-NEUTRAL INDICATOR CONTROL CIRCUIT LOW (CONTINUED)
3.
(G95) 4WD NEUTRAL INDICATOR CIRCUIT SHORT TO GROUND
Disconnect the Transfer Case Selector Switch connector.
Measure the resistance between ground and the (G95) 4WD Neutral
Indicator circuit.
Is the resistance below 5.0 ohms?
Yes
>> Repair the (G95) 4WD Neutral Indicator circuit for a short
to ground.
Perform the TRANSFER CASE VERIFICATION TEST-
VER 1.
No
>> Go to 5
4.
(G95) 4WD NEUTRAL INDICATOR CIRCUIT OPEN
Disconnect the Transfer Case Selector Switch connector.
Measure the resistance of the (G95) 4WD Neutral Indicator circuit.
Is the resistance above 5.0 ohms?
Yes
>> Repair the open (G95) 4WD Neutral Indicator circuit.
Perform the TRANSFER CASE VERIFICATION TEST-
VER 1.
No
>> Go to 6
21 - 980
TRANSFER CASE - ELECTRICAL DIAGNOSTICS
WK
C230A-NEUTRAL INDICATOR CONTROL CIRCUIT LOW (CONTINUED)
5.
TRANSFER CASE SELECTOR SWITCH
View repair.
Repair
Replace the Transfer Case Selector Switch in accordance with the Service information.
Perform the TRANSFER CASE VERIFICATION TEST-VER 1.
6.
FINAL DRIVE CONTROL MODULE
View repair.
Repair
Replace the Final Drive Control Module in accordance with the Service information.
Perform the TRANSFER CASE VERIFICATION TEST-VER 1.
7.
INTERMITTENT WIRING AND CONNECTORS
The conditions necessary to set this DTC are not present at this time.
Using the wiring diagram/schematic as a guide, inspect the wiring and connectors.
While monitoring the scan tool data relative to this circuit, wiggle test the wiring and connectors.
Look for the data to change or for the DTC to reset during the wiggle test.
Were any problems found?
Yes
>> Repair as necessary.
Perform the TRANSFER CASE VERIFICATION TEST-VER 1.
No
>> Test complete.
WK
TRANSFER CASE - ELECTRICAL DIAGNOSTICS
21 - 981
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст