Jeep Grand Cherokee WK. Manual — part 1219
13. Install cylinder head covers (1) (Refer to 9 -
ENGINE/CYLINDER
HEAD/CYLINDER
HEAD
COVER(S) - INSTALLATION).
14. Connect the evaporation control system.
15. Install the air cleaner (Refer to 9 - ENGINE/AIR
INTAKE SYSTEM - INSTALLATION).
16. Fill cooling system (Refer to 7 - COOLING -
STANDARD PROCEDURE).
17. Connect the negative cable to the battery.
18. Start engine check for leaks.
COVER-CYLINDER HEAD
REMOVAL
1. Disconnect battery negative cable.
2. Disconnect coil on plug connectors (4).
9 - 1472
ENGINE - 5.7L SERVICE INFORMATION
WK
CAUTION: The ground straps must be installed in
the same location as removed. The covers are
machined to accept the ground straps in those
locations only.
3. Remove cylinder head cover retaining bolts, and
ground straps.
WK
ENGINE - 5.7L SERVICE INFORMATION
9 - 1473
4. Remove cylinder head cover (1).
9 - 1474
ENGINE - 5.7L SERVICE INFORMATION
WK
NOTE: The gasket (2) may be used again, provided no cuts, tears, or deformation has occurred.
INSTALLATION
CAUTION: Do not use harsh cleaners to clean the
cylinder head covers. Severe damage to covers
may occur.
CAUTION:
DO
NOT
allow
other
components
including the wire harness to rest on or against
the engine cylinder head cover. Prolonged contact
with other objects may wear a hole in the cylinder
head cover.
1. Clean cylinder head cover (1) and both sealing sur-
faces (1,4,). Inspect and replace gasket (2) as
necessary.
WK
ENGINE - 5.7L SERVICE INFORMATION
9 - 1475
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст