Jeep Grand Cherokee WK. Manual — part 1596
HANDLE-EXTERIOR
REMOVAL
1. Remove the window regulator from the inside of
the rear door (Refer to 23 - BODY/DOORS -
REAR/WINDOW REGULATOR - REMOVAL).
2. Disconnect the actuator rod (1) from the rear exte-
rior handle (2).
3. Remove the three bolts (2) that secure the exterior
handle (1) to the rear door and remove the handle.
23 - 42
DOORS - REAR
WK
INSTALLATION
1. Position the exterior handle (1) to the mounting
hole on the outside of the rear door.
2. Install the three bolts (2) that secure that exterior
handle to the door. Tighten the bolts to 5 N·m (44
in. lbs.).
3. Connect the actuator rod (1) to the rear exterior
handle (2).
4. Install the rear window regulator (Refer to 23 -
BODY/DOORS - REAR/WINDOW REGULATOR -
INSTALLATION).
WK
DOORS - REAR
23 - 43
HINGE
REMOVAL
1. Disconnect and isolate the negative battery cable.
2. Disconnect the rear door wire harness connector
from the body wire harness.
3. Using a grease pencil or equivalent, mark the loca-
tion of the rear door hinges (2 and 3) on the B-pil-
lar.
4. Support the rear door with a suitable lifting device
and remove the four bolts (1 and 4) that secure the
rear door hinges to the B-pillar.
5. Carefully remove the rear door from the body and
place it on a workbench.
6. Using a grease pencil or equivalent, mark the loca-
tion of the door hinges (2 and 3) on the rear door.
NOTE: The epoxy bonded washers do not need to
be separated from the door hinges. If the washers
are removed, the door may need to be readjusted.
7. Remove the four nuts (4) that secure the rear door
hinges to the door and remove the hinges.
8. If required, remove the washers (1) from the rear
door hinges.
23 - 44
DOORS - REAR
WK
INSTALLATION
1. Position the rear door hinges onto the door.
NOTE: If the epoxy bonded washers are separated
from the door hinges, the door may need to be
adjusted.
2. If removed, install the epoxy bonded washers (1).
3. Loosely install the nuts (4) that secure the hinges
to the rear door.
4. Align the hinges to the door using the reference
marks made during the removal procedure and
tighten the nuts to 28 N·m (21 ft. lbs.).
5. Carefully position the rear door to the body and
support the door with a suitable lifting device.
6. Loosely install the four bolts (1 and 4) that secure
the rear door hinges (2 and 3) to the B-pillar.
7. Align the rear door to the body using the reference
marks made during the removal procedure and
tighten the bolts to 28 N·m (21 ft. lbs.).
8. Connect the rear door wire harness to the body
wire harness.
9. Reconnect the negative battery cable.
10. If necessary, adjust the rear door (Refer to 23 -
BODY/DOORS
-
REAR/DOOR
-
ADJUSTMENTS).
WK
DOORS - REAR
23 - 45
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст