Jeep Grand Cherokee WK. Manual — part 104
15. Remove the steering column opening cover (2)
and hush panel.
16. Remove retainer clip that holds booster push rod
(1) on pedal pin (2). Then slide push rod off pin.
17. Disconnect the brake lamp switch wire connector.
18. Remove the brake lamp switch.
19. Remove four nuts (3) that attach booster to dash
panel.
5 - 42
BRAKES - BASE - SERVICE INFORMATION
WK
20. In the engine compartment, disconnect the wire
harness routing clips (3) and move the harness
(1) to the side and downward.
21. Remove the booster (1) from the vehicle.
INSTALLATION
1. Check condition of grommet that secures check
valve in booster. Replace grommet if cut, torn, or
loose.
2. Install new booster dash seal.
3. Align and position booster in the mounting holes
(2) of the dash panel.
WK
BRAKES - BASE - SERVICE INFORMATION
5 - 43
4. Inside the vehicle, Lubricate pedal pin Mopar multi-
mileage grease.
5. Install booster attaching nuts (3) on studs. Tighten
attaching nuts to 39 N·m (29 ft. lbs.).
6. Slide booster push rod (1) on pedal pin. Then
secure rod to pin with retainer clip.
7. Install a new brake lamp switch and reconnect the
electrical connector.
5 - 44
BRAKES - BASE - SERVICE INFORMATION
WK
8. Install the steering column opening cover (2).
9. Install the hush panel (2).
10. In engine compartment, attach vacuum hose to
booster check valve (1).
WK
BRAKES - BASE - SERVICE INFORMATION
5 - 45
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст