Jeep Grand Cherokee WK. Manual — part 23
1. Position the upper suspension arm (2) in the frame
rail bracket.
2. Install the mounting bolt (5) and nut (1) tighten to
129 N·m (95 ft. lbs.).
3. Position the upper suspension arm (4) in the axle
bracket.
4. Install the mounting bolt (3) and nut (2) tighten to
136 N·m (100 ft. lbs.).
5. Raise the fuel tank back into place and secure
(Refer to 14 - FUEL SYSTEM/FUEL DELIVERY/
FUEL TANK - INSTALLATION).
6. Remove the supports and lower the vehicle.
RIGHT SIDE
NOTE: All torques should be done with vehicle on the ground with full vehicle weight.
2 - 56
REAR
WK
1. Position the upper suspension arm (2) in the frame
rail bracket.
2. Install the mounting bolt (5) and nut (1) tighten to
129 N·m (95 ft. lbs.).
3. Position the upper suspension arm (4) in the axle
bracket.
4. Install the mounting bolt (3) and nut (2) tighten to
136 N·m (100 ft. lbs.).
5. Remove the supports and lower the vehicle.
SHOCK
DESCRIPTION
The top of the shock absorbers are bolted to the body. The bottom of the shocks are bolted to the axle brackets.
The standard shocks have conventional twin tube construction and are low pressure gas charged. Gas charging
prevents cavitation during rough road operation.
OPERATION
The shock absorbers dampen jounce and rebound motion of the vehicle over various road conditions and limit sus-
pension rebound travel.
WK
REAR
2 - 57
REMOVAL
1. Raise and support the vehicle. Position a hydraulic
jack under the axle to support the axle.
2. Remove the upper nut and bolt (1) from the frame
bracket.
3. Remove the lower nut and bolt from the axle
bracket (2). Remove the shock absorber (1).
2 - 58
REAR
WK
INSTALLATION
1. Install the shock absorber (2) in the frame bracket
and install the bolt (1) and nut.
2. Install the shock absorber (1) in the axle bracket
(2) and install the bolt and nut.
3. Tighten the upper mounting nuts to 95 N·m (70 ft.
lbs.). Tighten the lower mounting nuts to 115 N·m
(85 ft. lbs.).
4. Remove the supports and lower the vehicle.
SPRING
DESCRIPTION
The coil springs mount up in the wheelhouse which is part of the unitized body bracket. A rubber doughnut isolator
is located between the top and bottom of the spring. The isolators provide road noise isolation
OPERATION
The coil springs control ride quality and maintain proper ride height.
WK
REAR
2 - 59
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст