Jeep Grand Cherokee WK. Manual — part 86
DIFFERENTIAL COVER
REMOVAL
1. With vehicle in neutral, position on hoist.
2. Remove fill plug (2).
3. Remove differential cover (1).
4. Drain fluid.
INSTALLATION
1. Apply a 6.35mm (1/4 in.) bead of Mopar
T
Gear
Sealant RTV Silicone Rubber Adhesive MS-GF44D
or equivalent to the cover.
CAUTION: If housing cover is not installed within
3 to 5 minutes, the cover must be cleaned and
new RTV applied. Failure to follow these instruc-
tions will result in a leak.
2. Install cover and tighten cover (1) bolts in a criss-
cross pattern to 41 N·m (30 ft. lbs.).
3. Fill differential and install fill plug.
3 - 242
REAR AXLE - C213RE
WK
AXLE SHAFTS
REMOVAL
1. With vehicle in netural, position on hoist.
2. Remove calipers and rotors.
3. Tap axle end plug (1) loose from the axle flange (2)
with a hammer and punch. Pull plug (1) out of axle
flange (2).
4. Remove speed sensors (2) from axle tube (1)
flange.
WK
REAR AXLE - C213RE
3 - 243
5. Remove axle flange nuts (1) from axle (2).
6. Pull axle shaft and backing plate out of axle tube
until axle bearing (1) is exposed.
7. Remove O-ring (2) from the axle bearing.
3 - 244
REAR AXLE - C213RE
WK
8. Slide axle shaft (1) from axle tube and backing
plate.
9. Tap axle shaft out of the bearing and axle flange
through the plug hole with a hammer and brass
drift.
INSTALLATION
1. Tap axle shaft into through axle bearing into axle
flange.
2. Install axle shaft (1) into axle tube and backing
plate with new o-ring on axle.
WK
REAR AXLE - C213RE
3 - 245
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст