Jeep Grand Cherokee WK. Manual — part 1198
INSTALLATION
CAUTION: The structural cover must be installed
as described in the following steps. Failure to do
so will cause severe damage to the cover.
1. Position the structural cover in the vehicle.
2. Install all four bolts (1,2,3)retaining the cover-to-en-
gine. DO NOT tighten the bolts at this time.
3. Install the four cover-to-transmission bolts (1,2,3).
Do NOT tighten at this time.
CAUTION: The structural cover must be held
tightly against both the engine and the transmis-
sion bell housing during tightening sequence. Fail-
ure to do so may cause damage to the cover.
4. Starting with the two rear cover-to-engine bolts,
tighten bolts (1) to 54 N·m (40 ft. lbs.), then tighten bolts (2) and (3) to 54 N·m ( 40 ft. lbs.) in the sequence
shown.
5. Install the exhaust pipe on left hand exhaust manifold.
6. Tighten exhaust manifold-to-exhaust pipe retaining bolts to 20–26 N·m (15–20 ft. lbs.).
MOUNT-ENGINE FRONT
REMOVAL
1. Disconnect negative battery cable.
2. Raise vehicle.
3. Remove engine mount thru bolts.
4. Raise engine using suitable jack.
5. Remove engine mount bolts (2).
6. Remove mount (1) from engine.
9 - 1388
ENGINE - 4.7L SERVICE INFORMATION
WK
INSTALLATION
1. Install the engine mount (1).
2. Lower the engine.
3. Install the thru bolts and nuts
4. Lower vehicle.
5. Connect negative battery cable.
MOUNT-ENGINE REAR
REMOVAL
4X2
1. Raise the vehicle on a hoist.
2. Using a suitable jack, support transmission.
3. Remove the crossmember.
4. Remove the fasteners (1) from the transmission
mount to transmission.
5. Remove the mount (3).
6. Remove the transmission mount bracket (2), if
required.
WK
ENGINE - 4.7L SERVICE INFORMATION
9 - 1389
4X4
1. Raise the vehicle on a hoist.
2. Using a suitable jack, support transmission.
3. Remove the crossmember.
4. Remove the fasteners (2) from the transmission
mount (1) to transmission.
5. Remove the mount.
INSTALLATION
4X2
1. Install the transmission mount bracket (2), if
removed.
2. Position the transmission mount (3) on the trans-
mission mount bracket (2). Install the fasteners
(1)that
attach
the
transmission
mount
to
the
bracket.
3. Torque the bolts to N·m ( ft.lbs.) torque.
4. Install the crossmember.
9 - 1390
ENGINE - 4.7L SERVICE INFORMATION
WK
4X4
1. Position the transmission mount (1) on the trans-
mission. Install the bolts (2) that attach the trans-
mission mount to the transmission.
2. Torque the bolts to N·m ( ft.lbs.) torque.
3. Install the crossmember.
LUBRICATION
DESCRIPTION
The lubrication system is a full flow filtration pressure feed type.
WK
ENGINE - 4.7L SERVICE INFORMATION
9 - 1391
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст