Jeep Grand Cherokee WK. Manual — part 1382
29. Connect wires to the line pressure sensor (2). Be
sure transmission harnesses are properly routed.
CAUTION: It is essential that correct length bolts
be used to attach the converter to the driveplate.
Bolts that are too long will damage the clutch sur-
face inside the converter.
30. Install all torque converter-to-driveplate bolts (3)
by hand.
31. Verify that the torque converter is pulled flush to
the driveplate. Tighten bolts to 31 N·m (270 in.
lbs.).
21 - 338
AUTOMATIC TRANSMISSION - 545RFE - SERVICE INFORMATION
WK
32. Install the structural cover (1), 5.7L shown. (Refer
to 9 - ENGINE/ENGINE BLOCK/STRUCTURAL
COVER - INSTALLATION)
33. If necessary, install the NV140 transfer case (1).
(Refer to 21 - TRANSMISSION/TRANSAXLE/
TRANSFER CASE - INSTALLATION)
34. If necessary, install the NV245 transfer case (1).
(Refer to 21 - TRANSMISSION/TRANSAXLE/
TRANSFER CASE - INSTALLATION)
WK
AUTOMATIC TRANSMISSION - 545RFE - SERVICE INFORMATION
21 - 339
35. Install starter motor. (Refer to 8 - ELECTRICAL/STARTING/STARTER MOTOR - INSTALLATION)
36. Install exhaust components.
37. Align and connect propeller shaft(s). (Refer to 3 - DIFFERENTIAL & DRIVELINE/PROPELLER SHAFT/PRO-
PELLER SHAFT - INSTALLATION)
38. Adjust gearshift cable if necessary. (Refer to 21 - TRANSMISSION/TRANSAXLE/AUTOMATIC - 45RFE/
545RFE/GEAR SHIFT CABLE - ADJUSTMENTS)
39. Lower vehicle.
40. Fill transmission with appropriate fluid. (Refer to LUBRICATION & MAINTENANCE/FLUID TYPES -
DESCRIPTION)
21 - 340
AUTOMATIC TRANSMISSION - 545RFE - SERVICE INFORMATION
WK
SCHEMATICS AND DIAGRAMS
HYDRAULIC SCHEMATICS
HYDRAULIC
FLOW
IN
P
ARK/NEUTRAL
WK
AUTOMATIC TRANSMISSION - 545RFE - SERVICE INFORMATION
21 - 341
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст