Jeep Grand Cherokee WK. Manual — part 259
EXPORT
1. Install antenna cable to the roof panel by pressing
retaining clips into position.
2. Connect antenna cable to the antenna module.
3. Connect antenna cable to the instrument panel
antenna cable.
4. Raise headliner into position.
5. Install A-pillar trim.
6. Install the right side sunvisor.
7. Install the assist handles.
8. Connect the battery negative cable.
ANTENNA CABLE - INSTRUMENT PANEL
REMOVAL
WARNING: DISABLE THE AIRBAG SYSTEM BEFORE ATTEMPTING ANY STEERING WHEEL, STEERING
COLUMN, SEAT BELT TENSIONER, SIDE AIRBAG, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR
SERVICE. DISCONNECT AND ISOLATE THE BATTERY NEGATIVE (GROUND) CABLE, THEN WAIT TWO MIN-
UTES FOR THE AIRBAG SYSTEM CAPACITOR TO DISCHARGE BEFORE PERFORMING FURTHER DIAGNO-
SIS OR SERVICE. THIS IS THE ONLY SURE WAY TO DISABLE THE AIRBAG SYSTEM. FAILURE TO TAKE
THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT AND POSSIBLE
PERSONAL INJURY.
8A - 172
AUDIO/VIDEO - SERVICE INFORMATION
WK
DOMESTIC
1. Disconnect and isolate the battery negative cable.
2. Remove radio (Refer to 8 - ELECTRICAL/AUDIO/
RADIO - REMOVAL).
CAUTION: Pulling the antenna cable straight out
of the radio without pulling on the locking antenna
connector could damage the cable or radio.
3. Disconnect the antenna cable by pulling the locking
antenna connector (2) away from the radio (1).
4. Remove the glove box.
5. Remove instrument panel side panel.
6. Disconnect
instrument
panel
cable
(1)
from
antenna body and cable (2).
7. Remove the antenna retaining straps and remove
antenna cable (4).
WK
AUDIO/VIDEO - SERVICE INFORMATION
8A - 173
EXPORT
WARNING:
DISABLE
THE
AIRBAG
SYSTEM
BEFORE ATTEMPTING ANY STEERING WHEEL,
STEERING COLUMN, SEAT BELT TENSIONER,
SIDE AIRBAG, OR INSTRUMENT PANEL COMPO-
NENT DIAGNOSIS OR SERVICE. DISCONNECT
AND
ISOLATE
THE
BATTERY
NEGATIVE
(GROUND) CABLE, THEN WAIT TWO MINUTES
FOR THE AIRBAG SYSTEM CAPACITOR TO DIS-
CHARGE BEFORE PERFORMING FURTHER DIAG-
NOSIS OR SERVICE. THIS IS THE ONLY SURE
WAY TO DISABLE THE AIRBAG SYSTEM. FAILURE
TO TAKE THE PROPER PRECAUTIONS COULD
RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT
AND POSSIBLE PERSONAL INJURY.
1. Disconnect and isolate the battery negative cable.
2. Remove the instrument panel (Refer to 23 - BODY/
INSTRUMENT
PANEL/INSTRUMENT
PANEL
ASSEMBLY - REMOVAL).
CAUTION: Pulling the antenna cable straight out of the radio without pulling on the locking antenna con-
nector could damage the cable or radio.
3. Disconnect the antenna cable by pulling the locking antenna connector (2) away from the radio (1).
4. Disengage each of the retainers that secure the
cable (2) to the instrument panel and remove
cable.
8A - 174
AUDIO/VIDEO - SERVICE INFORMATION
WK
INSTALLATION
DOMESTIC
1. Install cable (3) to instrument panel and secure into
place.
2. Connect instrument panel cable (1) to antenna
body and cable (2).
3. Install instrument panel side panel.
4. Install glove box.
WK
AUDIO/VIDEO - SERVICE INFORMATION
8A - 175
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст